Panasonic AK-HRP200G Operating Instructions Manual

Also see for AK-HRP200G: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

Panasonic AK-HRP200G Operating Instructions Manual Manual pdf 5 page image

5Operation.modes. (continued)Operation.mode.setting.procedureIn the factory default state, connect the CCU, remote camera or camera recorder to the unit and then set the operation mode.In the factory default state, connect the CCU, remote camera or camera recorder to the unit(for details, refer to Operating Instructions ).Operation in IP connection modeOperation in serial connection mode1. In Easy IP Setup Software,set the IP addresses of theCCUs and remote cameras(→ page 33).Set the IP address of thecamera recorder from themenu on the unit.3. Connect to the CCU and remotecameras/camera recorders in IPconnection mode and then startoperation.1. Select CCU in the serialsetting in setup mode(→ page 17).When connecting to a CCUwith a serial connection2. Connect to the CCU in serialconnection mode and thenstart operation.When connecting to a remotecamera with a serial connection1. Select remote camera in theserial setting in setup mode(→ page 17).2. Connect to the remote camerain serial connection mode andthen start operation.When connecting to a camerarecorder with a serial connection1. Select camera recorder in theserial setting in setup mode(→ page 17).2. Connect to the camerarecorder in serial connectionmode and then start operation.2. In ROP Setup Software, set theremote camera configurationfile to assign to each cameranumber (→ page 35)..z About.the.IP.connection.mode.settingsDo not start Easy IP Setup Software and ROP Setup Software during operation.The ROP will be disconnected, which in turn may cause a problem with operation.