13Setup.Mode.Operations.(continued)5.Save.ROP.configuration.file.to/load.ROP.configuration.file.from.memory.cardPress..select.menu.number.[5].CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNSelect y (Select)/n (Cancel)Save file indicationLoad file indicationPress to select themenu numberPress to exit setup mode(hold down)Press to confirmPress to save/load5-1.Save.ROP.configuration.file.to.memory.card1..Press..to.select.[ND].•Each press of toggles between [ND] (Save) and[CC] (load).NDM.GAINIRISM.PEDCCSHTSYNC2..Press..or..to.select.[y].and.press..to.confirm.the.selection.•Do not remove a memory card that is being accessed.NDM.GAINIRISM.PEDCCSHTSYNC•To cancel saving, select [n] and press .•The file is saved to the memory card and [Fin] appears when savingends.•[E02] is displayed if the save operation to the memory card fails.(→page 20)If this happens, check the memory card and try again or insertanother memory card to perform the operation again.•[E01] is displayed when an ROP configuration file with the samename as the one you are attempting to save already exists on thememory card.To overwrite the file, press or to select [y] andpress .(→page 20)•The data set in setup mode and ROP Setup Software is saved tothe memory card.•The following data is not saved.- IP address of the unit- Subnet mask of the unit- Default gateway of the unit- Port setting of the unit•To exit setup mode, hold down for about 2 seconds.•To make other settings, press 5-2.Load.ROP.configuration.file.from.memory.cardWhen the ROP configuration file is loaded, the setting data stored onthe memory card is loaded. If the operation mode of the unit and theoperation mode in the memory card differ, the operation mode changesto the operation mode saved in the memory card.1..Press..to.select.[CC].•Each press of toggles between [ND] (Save) and[CC] (load).NDM.GAINIRISM.PEDCCSHTSYNC2..Press..or..to.select.[y].and.press..to.confirm.the.selection.•The file is loaded from the memory card and [Fin] appears whenloading ends. A few seconds later, the unit is restarted.•Do not remove a memory card that is being accessed.NDM.GAINIRISM.PEDCCSHTSYNC•To cancel loading, select [n] and press .•[E02] is displayed if the load operation from the memory card fails.(→page 20)If this happens, check the memory card and see whether the fileexists on the memory card. If it does, start over from step 1.•To exit setup mode, hold down for about 2 seconds.6.Format.memory.card1..Press..select.menu.number.[6].CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNSelect y (Format)/n (Cancel)Press to select themenu numberPress to exit setup mode(hold down)Press to confirm2..Press..or..to.select.[y].and.press..to.confirm.the.selection.•Card formatting starts.•Do not remove a memory card that is being accessed.NDM.GAINIRISM.PEDCCSHTSYNC•To cancel formatting, select [n] and press .•When the formatting ends, [Fin] appears.•To exit setup mode, hold down for about 2 seconds.•To make other settings, press Be sure to execute a format after confirming the data because any datathat is deleted by the format cannot be recovered.
