10Setup.Mode.Operations1.Set.camera.number1..Open.setup.mode.and.check.that.menu.number.[1].is.displayed..If.a.menu.number.other.than.[1].appears,.press..to.select.menu.number.[1].CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNPress to select themenu numberPress to exit setup mode(hold down)Press to confirm the camera numberPress to select the camera number2..Press..or..to.select.a.camera.number.and.press..to.confirm.the.selection.NDM.GAINIRISM.PEDCCSHTSYNCTo select camera number 2•Camera numbers become available after exiting setup mode.•To exit setup mode, hold down for about 2 seconds.•To make other settings, press For AK-HC3500A, the camera numbers 1 to 15 are valid. Whenconnecting to AK-HC3500A, do not set a camera number to 16 orabove.2.Save.scene.file.to/load.scene.file.from.memory.cardCurrent operating status data is saved as a scene file to the memorycard.Press..select.menu.number.[2].CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNNDCCPress to select themenu numberPress to exit setup mode(hold down)Press to confirmSelect file number,Select y (Select)/n (Cancel)Press to save/loadSave file indicationLoad file indication2-1.Save.scene.file.to.memory.cardBefore switching to setup mode, open the scene file you wish to savewith the SCENE/USER FILE select buttons. (For details on how to opena scene file, refer to Operating Instructions .)1..Press..to.select.[ND].•Each press of toggles between [ND] (Save) and[CC] (load).NDM.GAINIRISM.PEDCCSHTSYNC2..Press..or..to.select.a.file.number.on.the.memory.card.and.press..to.confirm.the.selection.NDM.GAINIRISM.PEDCCSHTSYNCTo save a file to file no. 2 on the memory card3..Press..or..to.select.[y].and.press..to.confirm.the.selection.•Do not remove a memory card that is being accessed.NDM.GAINIRISM.PEDCCSHTSYNC•To cancel saving, select [n] and press .•The file is saved to the memory card and [Fin] appears when savingends.•[E02] is displayed if the save operation to the memory card fails.(→page 20)If this happens, check the memory card and try again or insertanother memory card to perform the operation again.•[E01] is displayed when a scene file with the same name as the oneyou are attempting to save already exists on the memory card.To overwrite the file, press or to select [y] andpress .(→page 20)•To exit setup mode, hold down for about 2 seconds.•To make other settings, press 2-2.Load.scene.file.from.memory.cardScene file data loaded from the memory card is returned to theoperating status. (It is not returned to scene files 1 to 4. To return thedata to scene files 1 to 4, exit setup mode and store the data in one ofscene files 1 to 4. For details, refer to , the instruction manual.)1..Press..to.select.[CC].•Each press of toggles between [ND] (Save) and[CC] (load).NDM.GAINIRISM.PEDCCSHTSYNC
