Panasonic AK-HRP200G Operating Instructions Manual

Also see for AK-HRP200G: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

Panasonic AK-HRP200G Operating Instructions Manual Manual pdf 39 page image

39ROP.Setup.software. (continued)Set.up.user.authentication.[User.Auth.]To control CCUs, remote cameras or camera recorders that have theuser authentication function enabled, you need to set the user name andpassword on the unit. Configure this setting on the [User Auth.] tab ofthis software.The user authentication function is only enabled when the unit iscontrolling CCUs, remote cameras or camera recorders connected withIP connection. Also refer to the operating instructions for the variousdevices.1234567 81..In.the.selection.list.box.(1),.select.the.ROP.for.which.you.want.to.make.connection.settings..• Click in the selection list box (1) to display the IP addressesof ROP units that can be set. From among these, select the ROPwhose IP address you want to set Any of the units registered on the[ROP List] tab can be selected.2..Click.the.[REFRESH].button.(7)..• The user name set on the ROP selected in the selection list box (1)is displayed in the [Old User Name] box (2).• The ROP factory default user name is [admin].3..In.the.[New.User.Name].box.(3),.enter.the.new.user.name.to.set..4..In.the.[Old.Password].box.(4),.enter.the.password.set.on.the.selected.ROP..• Entered characters are displayed as [*].• The ROP factory default password is [12345].5..In.the.[New.Password].box.(5),.enter.the.new.password.to.set...• Entered characters are displayed as [*].6..In.the.[Retype.New.Password].box.(6),.enter.the.same.password.entered.in.step.5..• Entered characters are displayed as [*].7..Click.the.[SET].button.(8)..• The user name and password are set on the ROP selected on thelist box (1).• When cameras with the user authentication function enabled arecontrolled, the user name and password that were set here areused..• Even if you have forgotten the new password you set by performingthe procedure above, you can still configure the settings again byentering [admin] in the [Old User Name] box and [12345] in the [OldPassword] box and then entering a new user name and password inthe other boxes.• Default user authentication settings for connected devices are asfollows.When user authentication is enabled, all connected devices musthave the same [USER NAME] and [PASSWORD].User.Name PasswordCCU admin 12345Remote camera admin 12345Camera recorder guest p2guest.z User.authentication.for.camera.recordersUser authentication is always enabled for camera recorders.In order to use IP connection with camera recorders, set userauthentication as follows. (When the camera recorder has thedefault settings)1..On.the.[User.Auth].tab,.set.the.user.authentication.(User.Name).and.password.(Password).as.follows.User Name: guestPassword: p2guest2..On.the.[Camera.List].tab,.set.the.camera.type.to.be.connected.(CAMERA.TYPE),.the.IP.address.(IP.ADDRESS).and.the.camera.port.number.(CAMERA.PORT.No).as.follows.CAMERA TYPE: Camcoder IPIP ADDRESS: 192.168.0.1CAMERA PORT NO. : 49152For settings and setting procedures applicable to camerarecorders, please refer to the camera recorder operatinginstructions.

/ 41

Related manuals for Panasonic AK-HRP200G