12Setup.Mode.Operations.(continued)3..Press..or..to.select.[y].and.press..to.confirm.the.selection.•Do not remove a memory card that is being accessed.NDM.GAINIRISM.PEDCCSHTSYNC•To cancel loading, select [n] and press .•The file is loaded from the memory card and [Fin] appears whenloading ends.•[E02] is displayed if the load operation from the memory card fails.(→page 20)If this happens, check the memory card and see whether the fileexists on the memory card. If it does, start over from step 1.•To exit setup mode, hold down for about 2 seconds.•To make other settings, press 4.Save.lens.file.to/load.lens.file.from.memory.cardPress..select.menu.number.[4].CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNSelect file number,Select y (Select)/n (Cancel)Save file indicationLoad file indicationPress to select themenu numberPress to exit setup mode(hold down)Press to confirmPress to save/load4-1.Save.lens.file.to.memory.cardBefore switching to setup mode, open the lens file you wish to save withthe ROP menu. (→page 31)1..Press..to.select.[ND].•Each press of toggles between [ND] (Save) and[CC] (load).NDM.GAINIRISM.PEDCCSHTSYNC2..Press..or..to.select.a.file.number.on.the.memory.card.and.press..to.confirm.the.selection.NDM.GAINIRISM.PEDCCSHTSYNCTo save a file to file no. 2 on the memory card3..Press..or..to.select.[y].and.press..to.confirm.the.selection.•Do not remove a memory card that is being accessed.NDM.GAINIRISM.PEDCCSHTSYNC•To cancel saving, select [n] and press .•The file is saved to the memory card and [Fin] appears when savingends.•[E02] is displayed if the save operation to the memory card fails.(→page 20)If this happens, check the memory card and try again or insertanother memory card to perform the operation again.•[E01] is displayed when a lens file with the same name as the oneyou are attempting to save already exists on the memory card.To overwrite the file, press or to select [y] andpress .(→page 20)•[E04] is displayed when the lens file is off.•To exit setup mode, hold down for about 2 seconds.•To make other settings, press 4-2.Load.lens.file.from.memory.card1..Press..to.select.[CC].•Each press of toggles it between [ND] (Save) and[CC] (Load).NDM.GAINIRISM.PEDCCSHTSYNC2..Press..or..to.select.a.file.number.on.the.memory.card.and.press..to.confirm.the.selection.NDM.GAINIRISM.PEDCCSHTSYNCTo load file no. 2 from the memory card3..Press..or..to.select.[y].and.press..to.confirm.the.selection.•Do not remove a memory card that is being accessed.NDM.GAINIRISM.PEDCCSHTSYNC•To cancel loading, select [n] and press .•The file is loaded from the memory card and [Fin] appears whenloading ends.•[E02] is displayed if the load operation from the memory card fails.(→page 20)If this happens, check the memory card and see whether the fileexists on the memory card. If it does, start over from step 1.•To exit setup mode, hold down for about 2 seconds.•To make other settings, press
