19Setup.Mode.Operations.(continued)2..Press..or..to.select.[y].and.press..to.confirm.the.selection.•Upgrading starts.NDM.GAINIRISM.PEDCCSHTSYNC•When the upgrade ends, [Fin] appears and the unit restartsautomatically.If the upgrade fails for some reason, may start to flash afterthe restart. If this happens, perform the upgrade process again.20.Set.tally.numberSet the camera number to assign to tally input.1..Press..to.select.menu.number.[20].CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNFlashesPress to select themenu numberPress to selectthe camera numberPress to confirmPress to exit setup mode (hold down)2..Press..or..to.select.a.camera.number.and.press..to.confirm.the.selection.NDM.GAINIRISM.PEDCCSHTSYNC•To exit setup mode, hold down for about 2 seconds.•To make other settings, press 21.Set.tally.outputSet the sending of tally information from the unit to remote cameras.1..Press..to.select.menu.number.[21].CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNFlashesPress to select themenu numberPress to select thecamera numberPress to confirmPress to exit setup mode (hold down)2..Press..or..to.select.[on].and.press..to.confirm.the.selection.NDM.GAINIRISM.PEDCCSHTSYNC•To exit setup mode, hold down for about 2 seconds.•To make other settings, press 22.Syncro.shutter.display.setting.Sets whether a camera recorder's syncro shutter speed is displayed inseconds (SEC) or in iris degrees (DEG).1..Press..to.select.menu.number.22..CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNFlashesPress to select themenu numberSelect SEC (seconds) orDEG (aperture angle)Press to confirmPress to exit setup mode (hold down)2..Press..or..to.select.[SEC].or.[dEG],.and.press..to.confirm.the.selection..NDM.GAINIRISM.PEDCCSHTSYNC23.Tally.control.setting.(for.camera.recorder.only)Specifies whether tally control is performed via panel operations orpreview terminal inputs.1..Press..to.select.menu.number.[23].CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNFlashesPress to select themenu numberSelect 1 (panel operation)/2 (preview terminal)Press to confirmPress to exit setup mode (hold down)
