18Setup.Mode.Operations.(continued)16.Initialize.settingsWhen settings are initialized, the unit is automatically restarted.Fordetails on what settings are initialized, refer to page 81..Press..select.menu.number.[16].CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNSelect y (Initialize)/n (Cancel)Press to select themenu numberPress to exit setup mode(hold down)Press to confirm2..Press..or..to.select.[y].and.press..to.confirm.the.selection.•After confirmation, unit settings are initialized and it is automaticallyrestarted.NDM.GAINIRISM.PEDCCSHTSYNC•To cancel initializing, select [n] and press .17.Confirm.versionPress..select.menu.number.[17].•The version information is displayed.•Press to show the 8-digit version number split up in 3,2 and 3 digits.CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNPress to select the menu numberPress to switch displaydigitsDisplay digit indication (first 3 digits)Display digit indication (middle 2 digit)Display digit indication (last 3 digits)Press to exit setup mode (hold down)•To exit setup mode, hold down for about 2 seconds.•To make other settings, press 18.Save.unit.data.to.memory.cardThis function is used by the manufacturer during maintenance.1..Press..select.menu.number.[18].CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNPress to select themenu numberPress to confirmSelect y (Save)/n (Cancel)Press to exit setup mode(hold down)2..Press..or..to.select.[y].and.press..to.confirm.the.selection.NDM.GAINIRISM.PEDCCSHTSYNC•The file is saved to the memory card and [Fin] appears when savingends.•[E02] is displayed if the save operation to the memory card fails.(→page 20)If this happens, check the memory card and try again or insertanother memory card to perform the operation again.•[E01] is displayed when a unit data file with the same name as theone you are attempting to save already exists on the memory card.To overwrite the file, press or to select [y] andpress . (→page 20)•To exit setup mode, hold down for about 2 seconds.•To make other settings, press 19.Software.upgradeFor details on software upgrades, refer to “Software upgrades” (→page3).1..Press..select.menu.number.[19].CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNSelect y (Upgrade)Press to select themenu numberPress to confirmPress to exit setup mode(hold down)
