34Setting.IP.addresses.of.devicesUse Easy IP Setup Software to set the IP address of each device.With this software, the ROP and CCU are also displayed as cameras.1..Start.Easy.IP.Setup.Software.A list of the devices connected with IP connections is displayed.2..Click.the.MAC.address.of.the.remote.camera,.ROP,.or.CCU.you.wish.to.set,.and.then.click.the.[Network.Settings].button.If there is an IP address conflict, the MAC addresses of thecorresponding cameras are displayed with drop shadows.3..Enter.each.of.the.network.items.and.then.click.[Save].Set [Network Settings] to [Static IP].Enter the setting information in [IPv4 address], [Subnet mask], and[Default gateway].Do not change any of the other settings.• If a firewall is activated, set the web browser or Easy IP SetupSoftware to the “Allow a program through Windows Firewall” setting.1. Open the control panel, and click [System and Security].2. Click [Allow a program through Windows Firewall] of [WindowsFirewall].3. Select the [Internet Explorer] or [EasyIpSetup] line, and then clickthe [Change settings] button.Check [Internet Explorer] or [EasyIpSetup].4. Click the [OK] button.• Setting of a CCU, remote camera, or ROP takes about 2 minutes tocomplete after clicking the [Save] button. If the AC adapter or a LANcable is removed before the settings are complete, the settings will notbe applied. In such a case, configure the settings again.• Set the network settings for the CCU from the menus of the CCU.For details, refer the operating instructions for the CCU.• Restart the CCU after changing of the settings is complete.• If a firewall (including software) exists, allow access to UDP for allports.• After the network settings have been configured, correct operation willnot be possible if an IP address is a duplicate of that of another devicewhich exists in the same network.Set IP addresses that will not be duplicates.• Do not configure the network settings from multiple instances of EasyIP Setup Software at the same time.Also, do not perform the auto IP setting operation of the AW-RP50 andAW-RP120 remote camera controllers at the same time.Doing so may result in the IP address settings becoming unknown.• If you are using Microsoft ® Windows ® XP Home Edition with SP3, theWindows Security Alert window may be displayed when you start EasyIP Setup Software.If that happens, click the [Unblock] button.• If you are using Microsoft ® Windows ® Vista, you may be asked to enterthe password for the administrator account when you start Easy IPSetup Software.If that happens, disable User Account Control from the Control Panel.• As a security enhancement measure, Easy IP Setup Software stopsdisplaying the MAC address and IP address of a target remote cameraafter about 20 minutes has elapsed since turning on the power.For details on setting the display time, refer to the operatinginstructions for the remote camera.• Easy IP Setup Software cannot be used from a different subnet via arouter.• IPv6 is not supported.Easy.IP.Setup.Software
