17Setup.Mode.Operations.(continued)Save.remote.camera.configuration.file.to.memory.card1..Press..to.select.[ND].•Each press of toggles between [ND] (Save) and[CC] (Load).NDM.GAINIRISM.PEDCCSHTSYNC2..Press..or..to.select.a.file.number.on.the.memory.card.and.press..to.confirm.the.selection.NDM.GAINIRISM.PEDCCSHTSYNCWhen saving to file number 2 on the memory card3..Press..or..to.select.[y].and.press..to.confirm.the.selection.•Do not remove a memory card that is being accessed.NDM.GAINIRISM.PEDCCSHTSYNC•To cancel saving, select [n] and press .•The file is saved to the memory card and [Fin] appears when savingends.•[E02] is displayed if the save operation to the memory card fails.If this happens, check the memory card and try again or insertanother memory card to perform the operation again.•[E01] is displayed when a remote camera configuration file with thesame name as the one you are attempting to save already exists onthe memory card. To overwrite the file, press or toselect [y] and press .•To exit setup mode, hold down for about 2 seconds.•To make other settings, press Load.remote.camera.configuration.file.from.memory.cardRemote camera configuration file data loaded from the memory card isreturned to the operating status.1..Press..to.select.[CC].Each press of toggles between [ND] (Save) and [CC](Load).NDM.GAINIRISM.PEDCCSHTSYNC2..Press..or..to.select.a.file.number.on.the.memory.card.and.press..to.confirm.the.selection.NDM.GAINIRISM.PEDCCSHTSYNCWhen loading file number 2 on the memory card3..Press..or..to.select.[y].and.press..to.confirm.the.selection.•Do not remove a memory card that is being accessed.NDM.GAINIRISM.PEDCCSHTSYNC•To cancel loading, select [n] and press .•The file is loaded from the memory card and [Fin] appears whenloading ends.•[E02] is displayed if the load operation from the memory card fails.If this happens, check the memory card and see whether the fileexists on the memory card. If it does, start over from step 1.•To exit setup mode, hold down for about 2 seconds.•To make other settings, press 15.Set.serialPress CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UPND/CCM.GAIN/M.PEDSHUTTERNDM.GAINIRISM.PED10-19CCSHTSYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNPress to select themenu number1 (Select CCU serial)/2 (Select remote camera serial)Press to confirmPress to exit setup mode (hold down)Setting.CCU.serialPress or to select [1] and press to confirmthe selection.NDM.GAINIRISM.PEDCCSHTSYNC•After the selection is confirmed, the unit restarts automatically.Setting.remote.camera.serialPress or to select [2] and press to confirmthe selection.NDM.GAINIRISM.PEDCCSHTSYNC•After the selection is confirmed, the unit restarts automatically.Setting.for.camera.recorder.serialPress or to select [3] and press to confirmthe selection.NDM.GAINIRISM.PEDCCSHTSYNC•After the selection is confirmed, the unit restarts automatically.
