35ROP.Setup.softwareFirst, register the IP address of the ROP on the [ROP List] tab of theROP Setup Software.Once the IP address has been registered, configure the settings ofdevices on the [Configuration] tab, [Camera List] tab, and [UserAuth.]tab.Upon starting the ROP Setup Software, the [Configuration] tab isdisplayed first.Configuration Click tabs to select them and register IPaddresses and make settings.When making settings from a personal computer using the ROP SetupSoftware, please pay attention to the following points.• Do not start up the ROP Setup Software while the unit is in the setupmode.• Do not start up the ROP Setup Software on another personal computeron the same network.• After using the setup software to configure connection settings, werecommend backing up the setting data. Save it to a memory cardwhile the unit is in setup modeNo. Item Reference.page5 Save ROP configuration file to memorycardpage 13Register.the.unit.in.the.ROP.Setup.Software.[ROP.List].On the [ROP List] tab, register the IP address of the unit in [HRP1] of theROP Setup Software.When connecting multiple ROPs to the network, register one of the unitsin [HRP1] and then register the other ROPs (AK-HRP200) connected tothe network. ROPs registered here can be selected from the list box ofthe [Camera List] tab. Up to 25 units can be registered.15 67 3 421..Set.IP.addresses.in.[HRP1]..1) On the [HRP1] line under ROP NO, (1) enter the IP address of theunit to be registered2) Click the [REGISTER] button (6) to confirm the [HRP1] setting.2..Make.settings.for.multiple.units..Settings can be made by the following two methods..z Register.IP.addresses.assigned.to.devices.in.the.IP.address.column.(2).in.the.same.manner.as.with.[HRP1]..z Click.the.[NETWORK.SEARCH].button.(5).to.acquire.information.for.the.HRP200s.in.the.same.segment.• A list is displayed in [HRP2] to [HRP25].Click the [REGISTER] button (6) to confirm the [HRP1] setting.Registered ROPs are displayed in the Master ROP Number (7) listbox.When.you.want.to.change.ROP.numbers.in.the.list.Swap HRP200s set as connection destinations between two ROPnumbers.1) Click in the SWAP ROP No. column (3).A list of ROP numbers [HRP2] to [HRP25] is displayed.2) Select the ROP number with which you want to make the swap.3) Click the [REGISTER] button (6) to confirm the change.The length of time required for setting after you click the[REGISTER] button (6) is proportional to the number of ROPsconnected. When there are 25 ROPs connected, it takes up toabout 10 minutes.3..Confirm.ROP.connection.on.the.network..Click the [CONNECTION CHECK] button (4) on the ROP No. rowcorresponding to the ROP to be checked.If communication is performed correctly, the green tally display of the applicable HRP200 flashes for 3 seconds. If itdoes not flash, check the settings and connection.
