Panasonic AK-HRP200G Operating Instructions Manual

Also see for AK-HRP200G: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

Panasonic AK-HRP200G Operating Instructions Manual Manual pdf 15 page image

15Setup.Mode.Operations. (continued)2..Press..or..to.select.7-segment.display.brightness.and.press..to.confirm.the.selection. NDM.GAINIRISM.PEDCC SHT SYNC• To exit setup mode, hold down for about 2 seconds.• To make other settings, press .to.select.menu.number.[10].• Block 1 of the IP address appears.CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UP ND/CC M.GAIN/M.PED SHUTTERNDM.GAINIRISM.PED 10-19CC SHT SYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNPress to select themenu numberPress to selectthe IP addressPress to switch the block Press to confirmPress to exit setup mode (hold down)Display/set block 1Display/set block 2Display/set block 3Display/set block 42..Press..to.select.[CC],.[SHT],.and.[SYNC].• The display changes in the order of block 1, block 2, block 3, andblock 4.• When changing the IP address, press or to changethe setting for each block.NDM.GAINIRISM.PEDCC SHT SYNC3..Press..to.confirm.the.IP.address.setting.• Pressing while block 4 is displayed confirms thesetting. NDM.GAINIRISM.PEDCC SHT SYNC• To exit setup mode, hold down for about 2 seconds.• If the IP address setting value has been changed, the unit willrestart automatically when you exit setup mode. If the setting valuehas not been changed, the unit will not restart.• To make other settings, press .to.select.menu.number.[11].• Block 1 of the subnet mask appears.CAMERANo.DATASETDISPLAY SELECTUPDOWNSET UP ND/CC M.GAIN/M.PED SHUTTERNDM.GAINIRISM.PED 10-19CC SHT SYNCSELECTEXECUTEEXITSAVE/LOADSHIFT+UP+DOWNDisplay/set block 1Display/set block 2Display/set block 3Display/set block 4Press to selectthe subnet maskPress to select themenu numberPress to switch the block Press to confirmPress to exit setup mode (hold down)2..Press..to.select.[CC],.[SHT],.and.[SYNC].NDM.GAINIRISM.PEDCC SHT SYNC• The display changes in the order of block 1, block 2, block 3, andblock 4.• When changing the subnet mask, press or tochange the setting for each block.3..Press..to.confirm.the.subnet.mask.setting.NDM.GAINIRISM.PEDCC SHT SYNC• Pressing while block 4 is displayed confirms thesetting.• To exit setup mode, hold down for about 2 seconds.• If the subnet mask setting value has been changed, the unit will restartautomatically when you exit setup mode. If the setting value has notbeen changed, the unit will not restart.• To make other settings, press / 41

Related manuals for Panasonic AK-HRP200G