8 †P LASMA MONITORHow to Attach Options to the Plasma MonitorYou can attach your optional mounts or stand to the plasma moni-tor in one of the following two ways:In the upright position.Lay the screen face down.Lay the protective sheet, which was wrapped around the monitorwhen it was packaged, beneath the screen surface so as not toscratch the screen face.This device cannot be used or installed without a separateTabletop Stand or other optional mounting accessory. Forproper installation it is strongly recommended to use atrained, NEC authorized service person. Failure to followcorrect mounting procedures could result in damage to theequipment or injury to the user or installer. Product war-ranty does not cover damage caused by improper installa-tion. Failure to follow these recommendations could re-sult in voiding your warranty.Ventilation Requirements for enclosuremountingTo allow heat to disperse, leave space between surrounding ob-jects as shown in the diagram to the right.50mm (1.97”)50mm (1.97”)31mm (1.22”) 31mm (1.22”)45mm(1.77”)* Use only Listed Cart or Stand, or mounting kit or provided bymanufacturer.
