P LASMA M ONITOR † 21Basic OperationBefore operating the remote control, be sure to turn on the main power to the plasma monitor.POWER OFFRGB 1POWER ONRGB 3RGB 2 / DVD / HDVIDEOEXIT PROCEEDPOSITION / CONTROLRP- 102Turning on the Main Power and Return to Standby ModeThe plasma monitor enters the standby mode and the POWER/STANDBY light is lit in orange when the power cable is pluggedinto the wall outlet.P O W E R / S T A N D B Y To turn the main power:Press the POWER button on the frontpanel of the plasma monitorThe main power will be turned on.The POWER/STANDBY light turns lit ingreen. To turn off the power(standby mode):Press the POWER button againThe plasma monitor is in standby mode.The POWER/STANDBY light turns lit inorange.P O W E R / S T A N D B YTurning On or Off the Power with the Remote ControlP O W E R / S T A N D B Y To turn on the plasma monitor:Make sure that the POWER/STANDBYlight turns lit in orange (standby).Press the POWER ON button on the re-mote control.The plasma monitor is turned on.The POWER/STANDBY light turns lit ingreen. To turn off the plasma monitor:Press the POWER OFF button on theremote control.The plasma monitor enters the standbymode.The POWER/STANDBY light turns lit inorange.P O W E R / S T A N D B Y* The standby mode used here is the condition that exists whenthe power management is on. This is not the standby mode setby the remote control's powering-off.
