NEC PlasmaSync 42PD3 User Manual

Also see for PlasmaSync 42PD3: Brochure & specs

Contents

NEC PlasmaSync 42PD3 User Manual Manual pdf 13 page image

P LASMA M ONITOR † 131110987654321Setup ProcedureDetermine the installation locationInstallation of only the plasma monitor is not possible. Be sure touse and install the plasma monitor in conjunction with a stand orspecial unit.CAUTION DO NOT ATTEMPT TO INSTALL THEPLASMA MONITOR.Installing your plasma display must be done by a qualified tech-nician. Contact your dealer for more information.CAUTION DO NOT USE THE RETRACTABLE FEETFOR PURPOSE OF PERMANENT INSTAL-LATION.The retractable feet are for temporary use only and are not in-tended for permanent installation.CAUTION MOVING OR INSTALLING THE PLASMAMONITOR MUST BE DONE BY TWO ORMORE PEOPLE.Failure to follow this caution may result in injury if the plasmamonitor falls.ImportantLay the protective sheet, which was wrapped around the plasma monitorwhen it was packaged, beneath the plasma monitor so as not to scratch thepanel.Install the plasma monitorIn setting up a multiple screen system, please give considerationto the cable length and type since image quality may be degraded.Install the remote control batteriesThe remote control is powered by 1.5V AA magnesium batteries.To install or replace batteries:¡ Press and slide to open the cover.™ Align the batteries according tothe (+) and (–) indications insidethe case.£ Replace the cover.Connect external equipment (See page 14)• To protect the connected equipment, turn off the main powerbefore making connections.• Refer to your equipment user manual.Connect the supplied power cable• The power outlet socket should be installed as near to the equip-ment as possible, and should be easily accessible.• Attach the supplied ferrite core to the power cable. See page50.• Fully insert the prongs into the power outlet socket. Loose con-nection may cause noise.Switch on the power of all the attached external equipmentWhen connected with a computer, switch on the power of the com-puter first.Operate the attached external equipment.Display the signal on the external equipment you wish.Select the input mode (See pages 22 and 27)Select the appropriate input.When the equipment is connected to the RGB 2/DVD/HD, makethe setting for the RGB 2 input. Make the VIDEO settings when aconnection has been made to VIDEO. When an audio signal isconnected, make the setting for sound.Adjust the sound (See page 27)Make adjustments when adjustment of the volume or balance isrequired.Adjust the screen (See pages 31 and 32)Make adjustments when adjustment of the screen display positionor distortion is required.Adjust the image (See page 28)Make adjustments when picture adjustment such as the bright-ness or contrast is required.