NEC PlasmaSync 42PD3 User Manual

Also see for PlasmaSync 42PD3: Brochure & specs

Contents

NEC PlasmaSync 42PD3 User Manual Manual pdf 12 page image

12 †PLASMA MONITORPart Names and FunctionsPOWER OFFRGB 1POWER ONRGB 3RGB 2 / DVD / HDVIDEOEXIT PROCEEDPOSITION / CONTROLRP -102928435176NOTE:* The wired/wireless remote control PX-RC2U is available as an option.* In addition to the features on the supplied remote control, the optional remote control has the following functions:• Direct remote button operation for picture adjustments such as contrast and brightness.• Direct remote button operation for picture and alignment adjustments such as horizontal and vertical position.• When the remote control is connected to the REMOTE IN jack with the remote cable, the optional remote control can be used as the wired remote control.The REMOTE OUT connector is used to connect multiple plasma monitors together and allows all of the plasma monitors to be controlled by one remotecontrol.• When you control multiple plasma monitors by the single remote control, you can assign an ID number to each plasma monitor so that all of the plasmamonitors are not be affected at the same time.POWER OFFRGB 1POWER ONRGB 3RGB 2 / DVD / HDVIDEOEXIT PROCEEDPOSITION / CONTROLRP - 102ImportantThe remote control system may not function when direct sunlight or strongillumination strikes the remote control sensor of the plasma monitor, orwhen there is an obstacle in the path. Should this happen, use the remotecontrol in the wired operation.Handling the remote controlRemote Control¡ POWER ON/OFF buttonSwitches the power on/off. See alsopage 21.* If the POWER/STANDBY lamp is notglowing, then these controls will notwork.™ RGB 1 buttonSelect the RGB1 input. See also page22.£ RGB 2 buttonSelect the RGB 2/DVD/HD input. Seealso page 22.¢ RGB 3 buttonSelect the RGB 3 input. See also page22.VIDEO buttonSelect the VIDEO input. See also page22.§ POSITION/CONTROL buttonsAdjust the image location horizontally and ver-tically. See also pages 25 and 31.These buttons executes the menu selection andconfirms adjustments/setting in the menu mode.¶ PROCEED buttonDisplays the on-screen menu (Menu mode).See also page 25.• EXIT buttonExits the on-screen menu or Menu mode. Seealso page 25.ª Infrared transmitterDirect the remote control toward the remotesensor on the plasma monitor. See also page12.Operating Range for the Remote ControlPoint the top of the remotecontrol toward the plasmamonitor's remote sensorduring button operation.Use the remote controlwithin a distance of about 7m/23 ft. from the front of theplasma monitor's remotecontrol sensor and at a hori-zontal and vertical angle ofwithin 30˚. Approx.7m/23ft30˚ 30˚* Do not subject to strong shock.* Do not allow water or other liquid to splash the remote con-trol. If the remote control gets wet, wipe it dry immediately.* Avoid exposure to heat and steam.