NEC PlasmaSync 42PD3 User Manual

Also see for PlasmaSync 42PD3: Brochure & specs

Contents

NEC PlasmaSync 42PD3 User Manual Manual pdf 45 page image

P LASMA M ONITOR † 45Move the cursor up and down withthe POSITION/CONTROL buttons.[LUM. LIMIT]:Suppresses the brightness ofthe screen.[ORBITING]:Moves the screen at a fixed pe-riod.* Cannot be set at the time of the 4-screen/9-screenmultiple system setting.[INV/WT]:Displays a negative/positive inverse image or an all-whitescreen.* The [INV] and [WT] settings will be switched to [OFF]when the power is switched on or off, and at the time ofinput signal selection. The last operating condition datawill not be stored in memory.[PROG. ORBIT...➝]:Align the cursor with [PROG. ORBIT...➝] and press thePROCEED button. The PROG. ORBIT MENU screen isdisplayed and the movement of screen dots can be setto be programmable.* When either [ORBITING] or [PROG. ORBIT] is set to[ON], the other one will be [OFF].* Note that if [PROG. ORBIT] is set to [ON], the dot display ofthe set portion will be lost on the screen* This setting is not available when the 4-screen/9-screenmultiple system is set.[LUM. LIMIT] and [ORBITING] settings[ON] : Long life function is operational.[OFF] : Cancelled[INV/WT] settings[INV] : Provides the negative/positive inverse image of thescreen.[WT] : Displays an all-white screen.[OFF] : Cancelled[PROG. ORBIT...➝] settings[SET] :[ON] : Function is operational.[OFF] : Cancelled.[H-DOT] :Moves from 1 to 20 dots in thehorizontal direction.[V-LINE] :Moves from 1 to 20 dots in thevertical direction.[TIME] :A 1- to 5-minute interval between movements.Long Life Settings (LONG LIFE MODE)Preparation Press the PROCEED button to display the main menu.1 Align the cursor with2Move the cursor left and right withthe POSITION/CONTROL buttons. LUM. LIMITORBITTINGINV / WTPROG. ORBIT . . . . . . . .GRAY LEVELALL RESET: OFF: OFF: OFF: 3LONG LIFE MODELUM. LIMITORBITTINGINV / WTPROG. ORBIT . . . . . . . .GRAY LEVELALL RESET: OFF: OFF: OFF: 3LONG LIFE MODEAlign the cursor with the desired itemThese settings reduce screen burn-in.Set [OSD MODE] to [PRO] on the configuration menu, then per-form the following operations.Long Life Settings (LONG LIFE MODE)43 Set the long life mode with the POSI-TION/CONTROL buttonsPress the EXIT button 2 timesPress the EXIT button one time to return to the main menu.One further press removes the menu.* Aligning the cursor with [ALL RESET] and pressing the PRO-CEED button will return all long life settings to the defaultsettings.SETH-DOTV-LINETIME: OFF: 5: 5: 1PROG. ORBIT MENUImportant Regarding CopyrightPlease note that using this monitor for the purpose of commercial gain orthe attraction of public attention in a venue such as a coffee shop or hoteland employing compression or expansion of the screen image with awide screen setting (of FULL, ZOOM, or STADIUM), etc., raises concernabout the infringement of copyright rights which are protected by copy-right law.