NEC PlasmaSync 42PD3 User Manual

Also see for PlasmaSync 42PD3: Brochure & specs

Contents

NEC PlasmaSync 42PD3 User Manual Manual pdf 29 page image

P LASMA M ONITOR † 29Auto Picture/Wide Screen Settings (AUTO PICTURE)There is normally no need to adjust the clock frequency or clock phase when [AUTO PICTURE] is set to [ON]; however, when automaticadjustment cannot adjust the picture properly, a manual adjustment should be made.Make an adjustment when a signal is newly input, and when vertical lines appear and the image appears blurred.Preparation Press the PROCEED button to display the main menu.41 Align the cursor with23Move the cursor left and right withthe POSITION/CONTROL buttons.AUTO PICTUREINPUT MODERGB MODEWIDE MODE : FULL: ON: 4X3: STILLAUTO PICTUREINPUT MODERGB MODEWIDE MODE : FULL: ON: 4X3: STILL: OFF: 4X3: STILLAUTO PICTUREINPUT MODERGB MODEPICTURE ADJFINE PICTUREWIDE MODE : FULLAlign the cursor with AUTO PICTURESelect OFF with the POSITION/CONTROL buttonsMove the cursor up and down withthe POSITION/CONTROL buttons.Align the cursor with the desired itemMove the cursor up and down withthe POSITION/CONTROL buttons.Clock Frequency/Clock Phase Adjustment, and RGB Mode Adjustment (AUTO PICTURE)56Adjust with the POSITION/CONTROL buttonsPress the EXIT button 2 times: OFF: 4X3: STILLAUTO PICTUREINPUT MODERGB MODEPICTURE ADJFINE PICTUREWIDE MODE : FULLINPUT MODE:[4x3], [16x9] and [16x9!] are used in the discrimination and switching ofthe input signal. See "INPUT MODE" of "Signal Identification For RasterPreset" (P.64) when making the setting.[RGB MODE] : Sets the mode (i.e., moving picture/stillpicture mode) to suit the input signal[PICTURE ADJ] : Adjusts the clock frequency[FINE PICTURE] : Adjusts the clock phasePress the EXIT button one time to return to the main menu.One further press removes the menu.Note: AUTO PICTUREAdjustment of [H-POSITION] and [V-POSITION] is not availablewhen [AUTO PICTURE] is set to [ON] at the time of RGB signal input.When adjustment is required, set [AUTO PICTURE] to [OFF].When the displayed image is small with respect to the original number ofhorizontal pixels (including instances where the display area, i.e., lit pix-els is small), the picture may take up to 6 seconds to be displayed. RGB MODE[MOTION] : Set when a moving picture source is connected such as ascan converter.[STILL] : Set when displaying a personal computer screen.[DTV] : Set when viewing a source such as a digital broadcast usingRGB input. Clock Frequency Adjustment (PICTURE ADJ)This adjusts the width of the image with respect to the screen.Adjustment is performed with a dot unit signal.Adjust to the position at which vertical flickering disappears. Clock Phase Adjustment (FINE PICTURE)Adjust for minimal screen noise, flicker, and color infidelity.First adjust the clock frequency, then perform the clock phase adjust-ment.* Clock frequency and clock phase adjustments are not available at thetime of VIDEO (and S-VIDEO) input.When the width of the image signal is wider than themonitor screen, adjust the size with the POSITION/CONTROL button.When the width of the image signal is narrower thanthe monitor screen, adjust the size with the POSITION/CONTROL button.: Monitor screen size : Image signal size