NEC PlasmaSync 42PD3 User Manual

Also see for PlasmaSync 42PD3: Brochure & specs

Contents

NEC PlasmaSync 42PD3 User Manual Manual pdf 19 page image

P LASMA M ONITOR † 19ConnectionsConnecting Your DVD PlayerConnecting your DVD player to your Plasma monitor will enable you to display your DVD' s video.Refer to your DVD player owner's manual for more information.* When [CINEMA PULLDOWN] is set to [ON] with another function menu and the film recording software that has filmed the video in 24frames per second (progressive) is played back, the plasma monitor fetches...3 frames, 2 frames and converts them into a 60 frames persecond progressive signal. (2-3 pulldown) Note that this is valid only for NTSC, PAL, and 480I (60 Hz) signals.Connect the Plasma Monitor to a DVD Player• To connect the RGB 2/DVD/HD IN connector (BNC) on the plasma monitor, use a separately available BNC connector cable. You willneed a separately available BNC-to-RCA adapter to connect a DVD player with an RCA pin jack to the BNC connector cable.Some DVD players may have different connectors such as Y,Cb/Pb, and Cr/Pr.Select [DVD/HD] for RGB 2 from the INPUT SELECT menu.When connecting one or more Plasma monitors, use the RGB 2/DVD/HD OUT connectors (BNC).• The AUDIO IN 1 and 2 (both RCA) can be both used for audio input. For connection, select [INPUT 1] or [INPUT 2] from the SOUNDmenu.AUDIO OUTL RAUDIO IN 2L(MONO) RVIDEOOUTS-VIDEO VIDEOAUDIO IN 1EXTERNAL CONTROLRGB 1L(MONO) RININ OUTINOUTINRGB 2/DVD /HDG/Y B/CB/PB H/CS VR/CR/PR REMOTERGB 3IN OUTC/LINPlasma monitorPlasma monitor (second monitor)BNC X3BNC X3BNC X3RCABNC X3BNC-to-RCA adapterTo audio right outputTo audio left output To DVD Component video outputTo RGB 2/DVD/HD INDVD player