48 †PLASMA MONITORAppendixOpening the Terminal CoverWhen connecting signal or other cables, the terminal cover of the monitor terminal section is opened to allow the connection to be made.After making the connection, close the terminal cover to permit cables to be arranged.12Raise the tab at the side of the terminal cover and open the ter-minal cover at the same time.Release the tab.12Raise the tab at the side of the terminal cover and close the ter-minal cover at the same time.Release the tab.Mounting of the Remote Control HolderA remote control holder can be mounted which will allow the remote control to be stored away when it isn't being used.12Insert the top portion of the remote control holder into the (up-per side) mounting holes at the left of the monitor terminal sec-tion.Insert the bottom portion of the remote control holder into the(lower side) mounting holes. (Insert until an engagement click isheard.)12Push up the bottom portion of the remote control holder anddisengage it.Disengage the upper portion of the remote control holder.Terminal coverTab12Remote controlholderClosing the Terminal CoverRemoving the Remote Control Holder
