NEC PlasmaSync 42PD3 User Manual

Also see for PlasmaSync 42PD3: Brochure & specs

Contents

NEC PlasmaSync 42PD3 User Manual Manual pdf 65 page image

P LASMA M ONITOR † 65VIDEO NTSC*1VIDEO PAL*1 VIDEO SECAM*1640 X 240 (15.734kHz/59.94Hz)768 X 288 (15.557kHz/50.39Hz)640 X 480 (31.469kHz/59.94Hz)640 X 480 (35kHz/66.667Hz)640 X 480 (37.861kHz/72.809Hz)640 X 480 (37.5kHz/75Hz)640 X 480 (43.269kHz/85.008Hz)640 X 480 (39.375kHz/75Hz)800 X 600 (35.156kHz/56.25Hz)800 X 600 (37.879kHz/60.31Hz)800 X 600 (48.077kHz/72.188Hz)800 X 600 (46.875kHz/75Hz)800 X 600 (53.674kHz/85.061Hz)832 X 624 (49.725kHz/74.55Hz)852 X 480 (31.722kHz/59.966Hz)848 X 480 (31.02kHz/60Hz)1024 X 768 (56.476kHz/70.069Hz)1024 X 768 (60.023kHz/75.029Hz)1024 X 768 (68.677kHz/84.997Hz)1024 X 768 (60.24kHz/74.93Hz)768 X 576 (31.389kHz/50Hz)640 X 480 (31.47kHz/59.9Hz)ISS-6010 NTSC*2ISS-6010 PAL*2VESA 480@60HzMAC @13''*5VESA 480@72Hz*3VESA 480@75HzVESA 480@85Hz*3XGA-2 480@75Hz*3VESA 600@56HzVESA 600@60HzVESA 600@72Hz*3VESA 600@75Hz*3VESA 600@85Hz*3MAC @16''*3*5I-O data wide*4VGA WIDE (NEC1)VESA 768@70Hz*3VESA 768@75Hz*3VESA 768@85Hz*3MAC @19''*3*5IDC-3000G PAL625PIDC-3000G NTSC 525P----STILL------------------MOTIONYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESYESFactorysettingsUsersettingsRGBMODE--4 X 3-4 X 3----4 X 34 X 34 X 3----16 X 9!16 X 9-----4 X 3INPUTMODE*7--NEGNEGNEG-NEGNEGPOSNEGPOSPOSPOSPOSPOS-NEGPOSNEGPOSPOS-NEGNEG--NEGNEGNEG-NEGNEGPOSNEGPOSPOSPOSPOSPOS-NEGPOSNEGPOSPOS-NEGNEGYESYESYES-YESYESYESYESYESYESYESYESYES-YESYESYESYESYES-YESYESYESYESYES-YESYESYESYESYESYESYESYESYES-YESYESYESYESYES-YESYESSync polarityVerHor VerHorResolution(horizontal frequency/vertical frequency)Presence/absence of syncSignal Identification For Raster PresetAppendix*1 Convert to 640 dots x 480 lines and display.*2 These signals cannot be displayed in the RGB3 input mode.*3 The picture will be shaky when the moving images of video games, etc., are input. (In this case set the refresh rate to 60 kHz or less.)*4 Only when using an I-O DATA graphic accelerator board.*5 Use a separately sold signal adapter (mini D-Sub 15-pin) when connecting to a Macintosh computer.For some models, make the mini D-Sub 15-pin connection using the included RGB signal cable.These signals are Sync On Green.*6 Make the settings to display these signals. The signals will not be displayed properly unless the correct settings are made.NOTE:* Input of a VGA or W-VGA signal is recommended because the display resolution is 853 x 480 pixels.For other cases, conversion is made to 640 dots x 480 lines or 853 dots x 480 lines.* 852 dot by 480 line signals are displayed with this resolution.* 848 dot by 480 line signals are displayed at a resolution of 848 dots by 480 lines when "NORMAL" is selected, and converted to 853 dots by 480 lines when "FULL"is selected.* At the time of video input, video signals derived from poor recording conditions may create poor images.* The sync may be disturbed when non-standard signals other than the aforementioned are input.* Multiple screens (2 screens) can only display signals having an aspect ratio of 4:3. *3 Cannot be used with multiple screens.* With digital inputs some signals are not accepted.* IBM PC/AT is a registered trademark of International Business Machines Corporation.* Macintosh is a registered trademark of Apple Computer, Inc.* VESA is a trademark of Video Electronics Standard Association.* DVI is an abbreviation for Digital Visual Interface.