NEC PlasmaSync 42PD3 User Manual

Also see for PlasmaSync 42PD3: Brochure & specs

Contents

NEC PlasmaSync 42PD3 User Manual Manual pdf 16 page image

16 †PLASMA MONITORConnecting Your Macintosh ComputerConnecting your Macintosh computer to your Plasma monitor will enable you to display yourcomputer's screen image. Some video cards or drivers may not display images correctly. (See also "Signal Identification For RasterPreset" on page 64.)Connect the Plasma Monitor to Your Macintosh• To connect the RGB 1 IN connector (mini D-sub 15 pin) on the plasma monitor, use the supplied RGB signal cable (mini D-sub 15 pin tomini D-sub 15 pin).For older Macintosh, use a pin adapter for Macintosh (available separately) to connect to your Macintosh's video port.The resolution modes that you can select are:• 13" fixed mode • 16" fixed mode • 19" fixed mode• To connect the RGB 2/DVD/HD IN connector (BNC) on the plasma monitor, use the signal cable available separately (mini D-sub 15 pinto BNC x 5).Select [RGB] for [RGB 2] from the INPUT SELECT menu.When connecting one or more Plasma monitors, use the RGB 2/DVD/HD OUT connector (BNC).• If you use with a Macintosh PowerBook, set "Mirroring" to Off.Refer to your Macintosh's owner's manual for more information about your computer's video output requirements and any specialidentification or configuring your monitor's image and monitor may require.• The AUDIO IN 1 and 2 (both RCA) can be both used for audio input. For connection, select [INPUT 1] or [INPUT 2] from the SOUNDmenu.AUDIO OUTL RAUDIO IN 2L(MONO) RVIDEOOUTS-VIDEO VIDEOAUDIO IN 1EXTERNAL CONTROLRGB 1L(MONO) RININ OUTINOUTINRGB 2 /DVD /HDG / Y B / C B / P B H / CS VR / C R / P R REMOTERGB 3IN OUTC/ LINPlasma monitorPlasma monitor (second monitor)To audio right outputTo RGB 2/DVD/HD INBNC x 5BNC x 5RCAMini D-sub 15 pinBNC x 5Mini D-sub 15 pinTo video output portMacintoshTo audio left outputConnectionsPin adapter forMacintosh