4–29COPYRIGHT © 1998 CANON INC. CANON NP6621 REV.0 FEB. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)MECHANICAL SYSTEM8) Remove the E-ring !1; then, remove the gear!2, parallel pin, and pulley cover (front/rear incommon).Figure 4-3579) Remove the end of the wire from the pulley(front/rear in common).10) Remove the fastener !3 from the wire relayassembly; then, remove the pulley cover, andremove the wire from the pulley (front/rear incommon).Figure 4-3586) Remove the mounting screw y from the front,and remove the oil damper plate u.Figure 4-3557) Remove the E-ring i from the lifter drive shaft(rear); then, remove the gear o, two washers,and spring !0.Figure 4-356769 10811 1213
