4–15COPYRIGHT © 1998 CANON INC. CANON NP6621 REV.0 FEB. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)MECHANICAL SYSTEMIII. PICK-UP/FEEDINGSYSTEMA. Pick-Up Assembly1. Removing the Pick-Up Roller Unit1) Remove the lower rear cover.2) Remove the grip ring q, and remove the pick-up clutch w.Reference:When removing the pick-up clutch, pull it offafter matching the cut-off e in the gear of theclutch against the turn stop.Figure 4-3013) Pull out the cassettes.4) Remove the E-ring r and the bushing t; then,remove the pick-up roller unit y.Figure 4-3022. Removing the Pick-Up Roller1) Remove the pick-up roller unit. (See “Removingthe Pick-Up Roller Unit.”)2) Remove the E-ring q, bushing w, spacer 1 eand spacer 2 r; then, remove the pick-up rollert.Figure 4-303Caution:Take care not to lose the pins from its front andrear.3. Points to Note When Installing thePick-Up RollerInstall the pick-up roller q so that the marking wshown in Figure 4-304 is at the rear. (However, theparallel pin will not fit in the groove.)Figure 4-3041 2 356445 2132 1
