ToolsXerox ® WorkCentre® 5022/5024 Multifunction PrinterUser Guide9-4List of Tools Menu Items Displayed in SystemAdministration ModeThe table below lists the default settings you can change. The items displayed will vary according toyour machine's configuration.Item Description See PageDefault Settings Used to set the default values of the setting items shown onthe control panel display.P. 9-8Copy Used to set the default values of the setting items in theCopy screen.P. 9-8ID Card Copy Used to set the default values of the setting items in the IDCard Copy screen.P. 9-10Scan Used to set the default values of the setting items in theScan screen.P. 9-10Fax Used to set the default values of the setting items in the Faxscreen.P. 9-12Device Information Used to check the Product Name, Serial Number, PrinterName, System Admin. E-mail Address, Firmware Version,IPv4, and IPv6 settings.P. 9-15Tray Settings Used to set the paper type (paper quality) in the papertrays. Also used to set the paper size for Paper Tray 5.P. 9-16Custom Paper Size Settings Used to set non-standard paper sizes for Customs (1 to 5)for Tray 5 (bypass).P. 9-18Control Panel Language Used to set the user interface language used in the controlpanel display.P. 9-19Default Display Used to set the initial screen to appear in the control panelat power on.P. 9-20Phone Book Used to creates a Phone Book for the fax transmissionfunction.P. 9-21Speed Dial Used to register and change names and fax numbers. P. 9-21Group Used to register or change groups for the Speed Dialfunction.P. 9-24Wired Network Used to make network environment settings. P. 9-27Ethernet Used to set the Ethernet environment to use. P. 9-27TCP/IP Used to set TCP/IP. P. 9-27IP Filter Used to restrict the IP addresses that can access themachine.P. 9-29
