Xerox ® WorkCentre® 5022/5024 Multifunction PrinterUser Guide9-19ToolsEach machine feature is set to factory default (initial) settings, but you can customize these settings tomatch your operating environment. You can change these settings in the Tools screen in SystemAdministration mode.Note Some settings cannot be displayed on certain models. An optional component is required. Formore information, contact our Customer Support Center.This chapter describes the functions you can change settings for and provides the settings procedures.System Settings ProcedureThis section gives an overview of how to change the machine's default settings and check machineinformation.Notes• If there are any current or pending jobs you cannot enter System Administration mode. If thereare no current or pending jobs and you still cannot enter System Administration mode, there maybe a background process running. Wait 5 minutes and try again.• While in System Administration mode you cannot receive a print job or start a print or scan job.Entering System Administration Mode1. Press and hold the Log In/Out button for at least 4 seconds.Log In/Out button
