Toshiba VFNC3-2001P Instruction Manual

E6581595D-144. Setting parameters4.1 Setting and Display ModesThe VF-nC3 has the following three display modes.Standard monitor mode The standard inverter mode. This mode is enabled wheninverter power goes on.Setting monitor mode The mode for setting inverter parameters.⇒ How to set parameters, refer to Section 4. 2.There are two parameter read modes. For details on selection and switching ofmodes, see 4.2.Easy setting mode : Only the seven most frequently used parameters aredisplayed.Parameters can be registered as necessary. (max. 24parameters)Standard setting mode : Both basic and extended all parameters are displayed.☆ Each press of the EASY key switches between the Easy setting mode and theStandard setting mode.This mode is for monitoring the output frequency and setting the frequency reference value. If alsodisplays information about status alarms during running and trips.・Display of output frequency, etc.f710 Initial panel display selection(f720 Initial remote keypad display selection)f702 Free unit display scale・Setting frequency reference values.・Status alarmIf there is an error in the inverter, the alarm signal and the frequency will flash alternately inthe LED display.: When a current flows at or higher than the overcurrent stall prevention level.: When a voltage is generated at or higher than the over voltage stall prevention level.: When the cumulative amount of overload reaches 50% or more of the overload tripvalue, or when the main circuit element temperature reaches the overload alarm level: When the overheat protection alarm level is reachedefesotomasyon.com -Toshiba inverter,drive,servo,plc