Toshiba VFNC3-2001P Instruction Manual

E6581595G-177. Operations with external signal7.1 Operating external signalsYou can control the inverter externally.The parameter settings differ depending upon your method of operation. Determine your method of operation (theoperational signal input method, speed command input method) before using the procedure below to set theparameters.[Procedure for setting parameters]Check external signal conditionsWith frequency command from panel keypad =  ( setting dial 1 ) =  ( setting dial 2 )With frequency command from external signal =  (terminal board VI)  ( RS485 communication)  (UP/DOWN from externallogic input)Run signal:Panel keypadSpeed command:Panel keypadRefer to 3.3Example 1)Run signal:Panel keypadSpeed command:Terminal boardRun signal:Terminal boardSpeed command:Panel keypadRun signal:Terminal boardSpeed command:Terminal boardWith run/stop from external signal =  (terminal board) *(RS485 communication)* Sink/source logic (I/O terminal logic)can be switched.For details, see 6.3.1.With run/stop from the Panel keypad =  (Panel keypad)Refer to 3.3Example 3)Refer to 3.3Example 2)Refer to 3.3Example 4)RUN STOP+* For settings based on communication, refer to the Communication Instruction Manual or section 6.22.efesotomasyon.com -Toshiba inverter,drive,servo,plc