Toshiba VFNC3-2001P Instruction Manual

E6581595F-3361) External connection2) Types of PID control interfacesSet process amount input value (frequency setting) for when doing PID control.Process amount input value (frequency setting) Feedback signalFrequency setup mode selection: 1: Setting dial 1 (press in center to save)2: Setting dial 2 (save even if power is off)3: RS485 communication5: UP/DOWN from external logic inputPreset-speed operation (=,  are all possible)External analog inputVI (DC: 4 - 20 mA/DC: 0 - 10 V/DC: 0 - 5 V)Note 1: Regarding setting value for : Terminal VI is used for a feed back signal, do not set =(terminal VI).3) Setting PID controlSet "" in the extended parameter  (PID control)(1) Set parameters (acceleration time), and  (deceleration time) to the system fitting values.(2) To limit the output frequency, set parameters  (upper limit frequency) and  (lower limitfrequency). If process quantities are set with the jog dial, however, the process quantity setting rangewill be limited by the settings of  and .MPR/L1S/L2T/L3U/T1V/T2W/T3VICCPressuretransmitter(1) Panel setting(2) Internal preset-speedsettingFeedback signals (1)DC : 4~20mA (2)DC : 0~10V (3)DC : 0~5V(1) Panel keypad settingefesotomasyon.com -Toshiba inverter,drive,servo,plc