E6581595F-686When sending an operation frequency command via a broadcast from the host computerＩＮＶＮｏ.２９ＩＮＶＮｏ.３０～～：Wiring：Data (Host→INV)ＩＮＶＮｏ.０３ＩＮＶＮｏ.０２ＩＮＶＮｏ.００★ ★ ★ ★★ＩＮＶＮｏ.０１Host computer+ : Split the cable among terminal blocks.(1) Send data from the host computer.(2) The inverters receive data from the host computer and the inverter number is checked.(3) When * is next to the position of an inverter number, it is judged a broadcast. The command isdecoded and processed.(4) To prevent data conflicts, only inverters where * is overwritten to 0 can reply with data to the hostcomputer.(5) As a result, all inverters are operating with the broadcast operation frequency command.Note: Specify inverter numbers by group for group broadcasts.(Function only for ASCII mode. For parity mode, see the Communications Function InstructionManual.)(Ex) When *1 is set, inverters 01, 11, 21, 31 to 91 can be broadcast to.In this case, the inverter specified in 01 can reply.6.20 Free memo : Free memo• FunctionTo enable easier management and maintenance of the inverter, it is possible to enter the identificationnumber.Q Parameter settingsTitle Function Adjustment range Standard defaults Free memo 0～65535 0efesotomasyon.com -Toshiba inverter,drive,servo,plc
