USO RESTRITO8-Keyer Operation 413Type SectionsusedOperation RefertoIndependentkey transitionTransitioncontrol blockInsert/delete DSK1 toDSK8 usingindependent keytransitions.p. 414Flexi Pad Set DSK1 to DSK8independent keytransitions.p. 415KeysnapshotsFlexi Pad Save/recall DSK1 toDSK8 key snapshots.p. 415KeyadjustmentsFlexi Pad Select DSK5 to DSK8in the Flexi Pad.p. 416Menu Select DSK5 to DSK8using the menu VFbuttons.p. 416Key wipes Devicecontrol blockSelect DSK5 to DSK8in the device controlblock.p. 416Menu Select to set key 1 to 4or key 1 to 8 as thekey wipe positionadjustment keys.p. 416Resizer Devicecontrol blockSelect key 5 or key 6resizer on the devicecontrol block.p. 417AppendixSelecting DSK1 to DSK8 using theNext Transition Selection ButtonsIn order to select DSK5 to DSK8 using the next transitionbuttons, it is first necessary to assign the buttons requiredfor operation in the Engineering Setup >Panel >TransitionModule menu (7321.9).For details, 1 “Setting Transition Control Block ButtonAssignments” (p. 327).Next transition selection buttonsNotesThe transition control block on the ICP-3000/3016 doesnot have buttons for inserting and deleting DSK5 to DSK8independent key transitions. You can insert and deleteDSK5 to DSK8 using the [KEY ON] and [AUTO TRNS]buttons on the Flexi Pad when in key snapshot mode.ADD buttonSHIFT button8- keyer transition control block(PGM/PST bank)The following describes how to select DSK1 and DSK5 asSelecting DSK5 to DSK8 Signals inthe 2nd Row of the Cross-PointControl BlockTo select the DSK5 to DSK8 signals using 2nd row cross-point buttons, it is necessary to assign the keyer delegationbuttons to the 1st row beforehand.You assign them in the same way as key 1 to key 4 in theEngineering Setup >Panel >Operation >Key/AUX/Function Assign menu (7326.13).For details, 1 “Assigning a Bus or Function to 1st RowButtons” (p. 340).1 In the 1st row, press the button assigned to one ofDSK5 to DSK8.2 In the 2nd row, select the desired signal.an example.To select DSK1With the [SHIFT] button off, press the [DSK1/DSK5]button.To select DSK5Press [SHIFT], turning it on, then press the [DSK1/DSK5]button.To select DSK1 and DSK5 simultaneously1 With the [SHIFT] button off, press the [DSK1/DSK5]button.DSK1 is selected.2 Press the [SHIFT] button, turning it on.3 Press and hold the [ADD] button, then press the[DSK1/DSK5] button.DSK1 and DSK5 are both selected.
