| 
USO RESTRITO274 Snapshot Operations in the MenusChapter 13 SnapshotsM/E, P/P: Indicates assignment of M/E-1 (ME1), P/P(P/P).User: Indicates the User1 (USR1) to User8 (USR8)assignments.DME: Indicates assignment of DME ch1 (DME1),ch2 (DME2), ch5 (DME5), ch6 (DME6), ch7(DME7), and ch8 (DME8).Misc: Indicates the Router (RTR) assignment.Editing Snapshot RegistersYou can carry out the following editing on snapshotregisters.You can use similar procedures also on master snapshot,wipe snapshot, DME wipe snapshot and key snapshotregisters.• Lock: Write-protect the contents of the register.• Copy: Copy the contents of one register to anotherregister.• Move: Move the contents of one register to anotherregister.• Swap: Swap the contents of two registers.• Delete: Delete the contents of a register.• Name: Attach a name to a register.For details about snapshot register operations, 1 “EffectRegister Editing” (p. 264).Displaying a List of SnapshotRegisters for EditingYou can display a list of snapshot registers including statusinformation (whether data is present and so on), then carryout lock, copy, delete, and rename operations.Displaying the list of snapshot registerswith status informationPress the menu title button at the top left of the Snapshotmenu.The Snapshot >Status menu (6300) appears.The status area shows a list of snapshot registers (1 to 99).For details about lock, copy, delete, and renameoperations, 1 “Displaying a List of Effect Registers forEditing” (p. 266).Register name displayFor the same number, the register name for the M/E-1region takes precedence.If there is no data for the M/E-1 region, then the registername appears in the sequence P/P >User1 to 8 >DME ch1,ch2, ch5 to ch8 >RTR.Operations in the Misc >SnapshotMenuTo limit the snapshot setting to the M/E or PGM/PSTbank, use the Misc menu for each bank.This section describes an example on the M/E-1 bank.Recalling a snapshot1 Open the M/E-1 >Misc >Snapshot menu (1177).2 As required, press [Bank Sel] to change the bank.3 Press the button for the number or name you want torecall.This recalls the snapshot, and the button you pressedlights green.Saving a snapshot1 Open the M/E-1 >Misc >Snapshot menu (1177).2 Set the state you want to save as a snapshot.3 Press [Store].4 As required, press [Bank Sel] to change the bank.5 Press the button for the number or name you want tosave.Applying attributesTo apply an attribute to the snapshot represented by a lit-green memory recall button, use the following procedure.1 To apply the cross-point hold attribute, in the group select the appropriate bus. |
