USO RESTRITOTally Generation Settings 375No. Parameter Adjustment1 DestinationAddressDestination address2 DestinationLevelDestination level3 Tally Type Tally typea)Chapter 22 Router Interface and Tally Setup3 Set the source.Source From: Specifies the source start address forthe wiring configuration.Source Level: Specifies the source level for the wiringconfiguration.No. Parameter Adjustment4 Source(From)Source start address5 Source(Level)Source level4 Press [Execute].The settings are common to the parallel and serial tallies.Making New Tally GenerationSettings1 Open the Engineering Setup >Router/Tally >TallyEnable >New menu (7364.1).2 Set the following parameters.Changing Wiring Settings1 Open the Engineering Setup >Router/Tally >Wiring>Modify menu (7363.2).2 Referring to steps 2 and 3 in “Making New WiringSettings” (1 p. 374), change the parameters asrequired. In this case, however, it is not possible tospecify multiple destinations in a single operation, anda single address in “Destination Address” must bespecified.3 Press [Execute].Deleting Wiring Settings1 In the Engineering Setup >Router/Tally >Wiringmenu (7363), select the wiring.2 Press [Delete].Sorting Wiring SettingsIn the Engineering Setup >Router/Tally >Wiring menu(7363), press [Sort].The sorting of wiring settings are executed in the followingorder.a) 1:R1, 2:G1, 3:R2, 4:G2, 5:R3, 6:G3, 7:R4, 8:G4, 9:R5, 10:G5, 11:R6,12:G6, 13:R7, 14:G7, 15:R8, and 16:G8 (R is an abbreviation of“Red Tally,” and G of “Green Tally”).3 In the group, specify the tallygeneration mode.Enable: Always generate a tally.Disable: Never generates a tally.Tally Input: Generates a tally from the tally input4 If you selected [Tally Input] as the tally generationmode in step 3, select either of the following in the group.DCU1: Generates tally with reference to signal inputto DCU1 port.DCU2: Generates tally with reference to signal inputto DCU2 port.5 Select the tally input port number.No. Parameter Adjustment5 Input No Tally input port number6 Press [Execute].Destination level order (ascending) t Destinationaddress order (ascending) t Source level order(ascending)Tally Generation SettingsYou specify the destination to be the reference for tallygeneration, and make various settings.Modifying Tally Generation1 Open the Engineering Setup >Router/Tally >TallyEnable >Modify menu (7364.2).2 With reference to steps 2 to 5 in “Making New TallyGeneration Settings” (1 p. 375), change theparameters as required.3 Press [Execute].
