| 
USO RESTRITO204 Applying Special Effects (Lighting and Recursive Effects)No. Parameter Adjustment1 Luminance Luminance2 Saturation Saturation3 Hue HueNo. Parameter Adjustment1 Intensity Intensity of diffuse light area2 Offset Offset of center of diffuse lightarea3 Width Width of diffuse light area4 Soft Softness of diffuse light areaNo. Parameter Adjustment1 Luminance Luminance2 Saturation Saturation3 Hue HueChapter 10 DME OperationsWith no selectionmade in the Light Mode> groupWith a selectionmade in the Light Mode> groupWidthSetting the bar mode of the highlight areaWhen you select [Bar] in step 3 of “Applying the Lightingeffect” (1 p. 202), use the following procedure to set thebar mode of the highlight area. Bar Light Diffuse LightNotesThe bar mode setting of the light area is not supported onthe MKS-6570 or MVE-8000A.1 Select the mode in the group of theLighting menu (4151).Normal: Emphasizes the bar highlight area.Specular: An effect like light striking a surface withmetallic reflections.Mat: An effect like light striking paper, cloth, oranother diffusively reflective surface.Trail SettingsNotesOffset = 02 Set the following parameters.3 When you select [Normal] or [Mat] in step 1, press[Bar Diffuse Color], turning it on, and adjust thefollowing parameters to set the color of the diffuselight area.When trail is turned on, any of the following effects thatare on are turned off: Motion Decay, Keyframe Strobe,Wind.Applying the Trail effect1 Open the DME >Light/Trail >Trail menu (4152).2 Press [Trail], turning it on.3 Set the following parameters.No. Parameter Adjustment1 Decay Degree to which the trail is left2 Interval Freeze interval3 Live Ratio of live video insertedbetween freeze images4 To erase the afterimages, press [Trail Eraser], turningit on.Switching the priority between the currentimage and trail superimposedIn the group of the Trail menu (4152), select themethod of superimposition.Over: Current image is on top.Under: Trail is on top. |
