Sony MVS-6520 User Manual

Also see for MKS-6550: Installation manual Manual Operating instructions

Contents

USO RESTRITO368 GPI Output SettingsNo. Parameter Adjustment1 From Slot First port slot2 From Port First port number3 To Slot Last port slot4 To Port Last port numberChapter 21 DCU Setup• Parallel Output Port: 1 to 364 Press [GPI Output Set].Releasing the Assignment of a GPIOutput Port1 In the Engineering Setup >DCU >Output Config menu(7353), select what the setting applies to (DCU1 orDCU2) from the group.2 In the group, if [GPI Output]is on, press it to turn it off.3 Select the slot and port to which the setting applies.4 In the group, press [NoAssign].GPI Output SettingsThis sets the trigger type and so on for each GPI output.Making DCU GPI Output Settings1 In the Engineering Setup >DCU >GPI Output Assignmenu (7354), select what the setting applies to.2 In the group, select the trigger type.(Rising Edge): The trigger causes the relaycontacts to be open-circuit or drives the outputhigh, and holds this state for the specified pulsewidth.(Falling Edge): The trigger causes the relaycontacts to be shorted or drives the output low, andholds this state for the specified pulse width.(Any Edge): Each time the trigger occurs, therelay contacts are alternately closed or opened, orthe output is switched between high and low.Status: Depending on the status, the relay contacts areclosed or opened, or the output is switchedbetween high and low.No Operation: The trigger has no effect on the relaystate or output level.3 Select the pulse width and timing to be set.No. Parameter Adjustment3 Pulse Width Pulse width4 Timing Output timinga)a) 1: Field 1, 2: Field 2, 3: AnyWhen “ ” is selected as the trigger polarity, there isno Pulse Width setting. When “Status” is selected,there is no Pulse Width or Timing setting.4 In the group, select the control panelor DCU to handle the GPI output.NotesThe SCU2 setting is disabled.When the action set in the following step 5 is carriedout on the control panel selected here, this causes aGPI output. It is also possible to output errorinformation.When the DCU is selected, you can output errorinformation by means of the action set in step 5.5 In the list on the right, select the action.6 Press [Action Set] to confirm the action selection.Selectable actions for various trigger types• When the trigger type is other than “Status”(The x in M/E-x is the M/E bank number, the x in DSKxis the DSK number, and the x in Keyx is the keynumber.)When Source Device is SCU: M/E-x Keyx SS ? Recall,P/P DSKx SS ? Recall, No ActionWhen Source Device is DCU: No Action• When the trigger type is “Status”(The x in M/E-x is the M/E bank number, the x in DSKxis the DSK number, and the x in Keyx is the keynumber.)When Source Device is SCU: M/E-x Keyx SS ? Recall,P/P DSKx SS ? Recall, M/E-x Keyx On, P/P DSKxOn, Error Make, Error Break, Keep Make, KeepBreak, Device Recording, No ActionWhen Source Device is DCU: Error Make, Error Break,No ActionTest firing the triggerPress [Test Fire].This outputs a trigger from the selected output port. This isno output when the trigger type is “Status.”