| 
USO RESTRITOBasic DME Wipe Setting Operations for Independent Key Transitions 119No. Parameter Adjustment1 H Horizontal position2 V Vertical positionChapter 6 DME Wipes“Dead Zone”TransitionsCroppingt: Transition execution timey: Change in transition andcropping amountDME Wipe Modify ClearPress [Default Recall] at the lower left of the menu screen,turning it on, then press the [DME Wipe] VF6 button toreturn the DME wipe settings to their initial status.Independent Key Transition DMEWipe Pattern SelectionFor details about patterns and pattern groups that can beselected, 1 “DME wipe execution mode and patternnumbers that can be used” (p. 112). Other patterns cannotbe selected, even if displayed on the screen. Also, patternscannot be used in two-channel mode on the MVS-3000.1 In the Key1 DME Wipe Adjust menu, press [1ch] inthe group for one-channel mode, or[2ch] for two-channel mode.The 1ch Pattern Select menu (1116.4) or 2ch PatternSelect menu (1116.5) appears.2 Press the button of the desired DME wipe patterngroup to select it.The selected group pattern appears on the screen.To perform a DME wipe using the resizerSelect [Resizer Slide], [Resizer Squeeze], or [ResizerFrame I/O] in the DME wipe group.3 Press the button to select the desired pattern.For details about initial status, 1 “Saving User-DefinedSettings” (p. 317).Basic DME Wipe SettingOperations forIndependent KeyTransitionsYou can set independent key transition DME wipes in theDME Wipe Adjust menu for each keyer.This section describes an example using key 1 on the M/E-1 bank.Open the M/E-1 >Key1 >Transition menu (1116), select[DME Wipe Adjust], and display the Key1 DME WipeAdjust menu (1116.3).For an overview of independent key transitions,1 “Independent Key Transitions” (p. 74).Setting Independent Key TransitionDME Wipe ModifiersYou can add modifiers such as pattern position and size foran independent key transition DME wipe.For an overview of modifiers, 1 “DME Wipe PatternVariations and Modifiers” (p. 114).Setting the DME wipe position (Positioner)For details about applicable pattern numbers, see“Positioner” in “DME Wipe Pattern Variations andModifiers” (1 p. 114).1 In the group of the Key1 DME WipeAdjust menu, press [Position], turning it on.2 Set the following parameters.To return the pattern position to the center of thescreenIn the group, press [Center]. |
