USO RESTRITO150 Misc Menu OperationsChapter 8 Color Backgrounds, Copy and Swap, and Other SettingsThe status area shows the setting status of each of thefollowing ports.• Switcher Remote S1 to Remote S2 ports (RS-422A,D-sub 9-pin)• Switcher GPI port (parallel, 25-pin)• DME2 GPI port (parallel, 25-pin)2 In the or group, press the nameof the port for which you want to disable control froman external device, turning it off.To enable control for the port, press the name again.NotesFor AUX bus operations from the Remote S1 toRemote S2 ports of the switcher, the setting (Enable/Disable/Manual) in the Setup menu takes precedence.The settings made in the Port Enable menu only applywhen the setting is set to [Manual].For details, 1 “Enabling or Disabling AUX BusControl” (p. 362).DME override mode1 Open the Misc >Enable >Port Enable menu (3211).2 In the group, select the DMEoverride mode.DME Override: When a switcher snapshot or effectusing a DME is recalled, forcibly select the DMEthat was used when saving.On Air Protect: The operation is the same as theDME override function, except that a DME beingused by an M/E bank or PGM/PST bank that is onair will not be forcibly selected.Notes• If effects using the same DME channel are selectedsimultaneously in two or more regions, the DME isselected with the order of precedence P/P >M/E-1.• This function is disabled on the MVS-3000.Enabling/disabling control from theSystem ManagerYou can perform some switcher data management andcontrol functions remotely by installing the BZPS-8000/8000L system management software (System Manager)on a networked computer.1 Open the Misc >Enable >Port Enable menu (3211).2 Press [System Manager].The setting is enabled/disabled each time the button ispressed.Safe Title SettingsTurning the safe title function on/off1 Open the Misc >Safe Title menu (3221).2 Select the signal to set.Notes• It is not possible to change the setting for the outputfor which the safe title is set off in the Setup menu.• The safe title function cannot be used for outputsignals for which through mode is set to Enable in aSetup menu.For details, 1 “Signal Output Settings” (p. 351).3 Press [Safe Title], turning it on or off.Displaying a List of Transition Ratesand Changing the SettingsIn the Misc >Transition >Key/ME/FTB menu (3231), foreach bank you can display a list of the M/E (or PGM/PST)transition rates and independent key (or DSK) transitionrates, and change the settings.These settings are linked to the other transition rate settingoperations.You can also display and set the fade-to-black transitionrate.Menu displayThe display of the independent key transition rate in theMisc >Transition >Key/ME/FTB menu (3231) depends onthe selection in the group of theEngineering Setup >Switcher >Transition menu (7334) foreach of the switcher banks.When [Same] (On direction and Off direction settingsare the same) is selected in the group: Only “Key” (or “DSK” in the PGM/PST bank)appears.When [Independ] (On direction and Off directionsettings are independent) is selected in the Transition> group: “Key(On)” and “Key(Off)” eachappear. In the PGM/PST bank, “DSK(On)” and“DSK(Off)” appear.For details, 1 “Settings Relating to Video Switching”(p. 355).
