| 
USO RESTRITO336 Setting Button AssignmentsCommand namea) Function Button statusLit amber OffDCU GPI1 Test Fire|DCU GPI50 Test FireOutput test trigger from port assignedto DCU GPI1|Output test trigger from port assignedto DCU GPI50Output (lights only atthe instant the buttonis pressed)When the output isassignedMacro Attachment Enbl Enable/disable macro attachment Enabled DisabledMacro Only Set Macro only mode on/off On OffPre Macro Set macro attachment in pre macromodeCan be set only whilepressed (lit)When the function isassignedPost Macro Set macro attachment in post macromodeCan be set only whilepressed (lit)When the function isassignedMacro Take Macro execution Execution suspended When the function isassignedMacro Cancel Cancel a macro Lit only at the instantthe button is pressedWhen the function isassignedMacro Auto Ins Macro auto insert mode on/off On OffMacro AT with Rate When registering an auto transitionmacro event, on/off setting of mode tosave transition rateOn OffMacro AT with A/B Bus When registering an auto transitionmacro event for the transition controlblock, on/off setting of mode to save A/B Bus cross-point settingsOn OffMacro TL with Region When registering a timeline macroevent, on/off setting of mode to saveapplicable regionOn OffDME Overrideb) DME override on/off On OffDME Graphic DME graphics on/off(Applies to graphics for channelselected in device control block)On OffSystem Manager Enbl Enable/disable operation from SystemManagerEnabled DisabledInhibit Set Inhibit cross-point button Can be set only whilepressed (lit)When the function isassignedInhibit All Clear Clear all cross-point button inhibitsettingsCan be set only whilepressed (lit)When the function isassignedK-SS Store Enable/disable key snapshot savingc) Enabled DisabledChapter 18 Control Panel Setupa) For the safe title on/off commands (from ME1 PGM1 ST–ME1 PGM4 STto AUX1 ST–AUX24 ST), the name of the assigned output signal isshown.b) MVS-6520/6530/3000A only.c) Pressing this button to turn it on enables key snapshot operations for allcontrol blocks.Assigning a Function to 2nd RowCross-Point ButtonsYou can assign functions to the 2nd row cross-pointbuttons for the M/E-1 and PGM/PST banks.1 Open the Engineering Setup >Panel >Prefs/Utility>Xpt Module Src/Reg Btn Assign menu (7324.2).2 Select the button to be assigned.3 In the group, select the function to beassigned.Menu Shortcut: Assigns a frequently used menu to berecalled (menu shortcut).Utility Command: Assigns a function enable/disableor similar operation (utility command).Macro Recall: Assigns a macro register recall.Shotbox Recall: Assigns a shotbox register recall.4 Depending on the selection in step 3, make thefollowing settings.If [Menu Shortcut] is selected: With the 2nd rowcross-point buttons flashing, press one of the |
