35CUSTOMER SET RELOCATIONThis program is used to swap information associated with two stations. All assign-ments such as trunk ring, station group, station COS, station speed dial etc. will fol-low this program. 18 button keysets and 28 button keysets can be exchanged. Ifincompatible set types are selected the system will provide an ERROR: NO MATCHmessage. 18 button and 28 button key assignments should be taken in consider-ation when relocating these type of sets.The table below shows which phones canbe switched with each other.NOTE: In order to use this program it must first be activated by a technician. Pleasesee your installing company to have this done if you wish to use this program. SetRelocation does not apply to ITP/SMT-i Series phones.PROGRAM KEYSUP & DOWN - Used to scroll through options.KEYPAD - Used to enter selections.SOFT KEYS - Move cursor left and right.SPK - Used to store data and advance to next program.HOLD - Used to clear previous entry.ANS/RLS - Used to select ALL.ACTION DISPLAY1. Press TRSF 315 SET RELOCATIONDisplay shows EXT _ EXT2. Enter first station number (e.g., 202) SET RELOCATIONPress RIGHT soft key to move cursor EXT 202 EXT _3. Enter second station number (e.g., 210) SET RELOCATIONPress RIGHT soft key to enter data EXT 202 EXT 2104. Display will return to STEP 1 SET RELOCATIONGo to STEP 2 EXT _ EXTOR press TRSF to store and exitprogramming.36[DCS Keysets and 32 button AOM not supported on the OS 7100].CUSTOMER SET RELOCATION ALLOW TABLESingleLineDCS*, DS &iDCS 64 AOM iDCS 8B iDCS 18B iDCS 28B DS5021D DS5014D DS5007SSingleLine YES NO NO NO NO NO NO NODCS*, DS& iDCS 64AOMNO YES NO NO NO NO NO NOiDCS 8B NO NO YES NO NO NO NO NOiDCS 18B NO NO NO YES YES NO NO NOiDCS 28B NO NO NO YES YES NO NO NODS5021D NO NO NO NO NO YES NO NODS5014D NO NO NO NO NO NO YES NODS5007S NO NO NO NO NO NO NO YES
