For the purposes of pro-gramming speed dial num-bers, the programmable but-tons are known as A, B, C, D, Eand F.• The A button is not used.• The B button inserts aflash.• The C button inserts apause.• The D button is used forpulse to tone conversion. If your system uses rotary (or pulse) dialing C.O. lines,pressing D while entering a speed dial number causes all subsequent digits tobe sent as DTMF tones.• The E button is used to hide digits. Display keyset users may want to hidesome speed dial numbers so that they will not show in the display. When youare entering a telephone number, press E. All subsequent digits will be hid-den. Press E again to begin displaying digits.• The F button is used to enter a name. See Personal Speed Dial Names underDisplay Features.• Use the HOLD button to clear a speed dial number.ONE TOUCH SPEED DIALINGYou may assign any speed dial number to an already existing One Touch SpeedDial button for quick and easy dialing of frequently used numbers.• While on-hook, press TRANSFER and then dial 107.• Press a One Touch Speed Dial button.• Dial the speed dial number (00–49 or 500–999) that you want assigned tothis button.• Press TRANSFER to store your selection.To call this telephone number, just press the One Touch Speed Dial button.NOTE: If the Hot Keypad feature has been turned off, you must first lift the handsetor press the SPEAKER button before you begin dialing.LAST NUMBER REDIALTo redial the last telephone number you dialed, press the REDIAL button or dial 19.NOTES:1. If the Hot Keypad feature has been turned off, you must first lift the handsetor press the SPEAKER button before you begin dialing.2. Redial does not apply to intercom calls.25A B C D E F24DIALING FEATURESAll “DIALING FEATURES” instructions are written to support Overlap Dialing mode.This is the technical name for dialing from a telephone as it has been for manyyears. In recent years the cell phone industry has changed the cell phones to useEnblock Dialing. With this dialing mode all the digits are dialed and then sent tothe carrier after pressing the SEND key. Please check your telephone setup to con-firm what dialing mode is used.SPEED DIALINGYou can dial a preprogrammed telephone number stored in the system-widespeed dial list of numbers 500~999 or from your personal list of numbers 00~49.Your system may be set for 950 system wide numbers. If so the system speed dialaccess codes are 050~999 and the station speed dial codes are 000~049.• With the handset on-hook, press the MEMORY button or dial 16.• Dial the desired speed dial number.• The telephone number is automatically dialed for you.NOTE: If the Hot Keypad feature has been turned off, you must first lift the handsetor press the SPEAKER button before you begin dialing.PROGRAMMING PERSONAL SPEEDDIAL NUMBERSYou can program frequently dialed telephone numbers in a personal speed diallist. A station may be assigned up to fifty numbers, 00–49. See your system admin-istrator to determine the amount assigned to your station.• While on-hook, press TRANSFER and then dial 105.• Dial a speed dial number (00–49).• Dial a line or line group access code.• Dial the telephone number to be stored (24 digits maximum). It can include #,, FLASH and PAUSE.• Press TRANSFER to store the number.NOTE: If the Hot Keypad feature has been turned off, you must first lift the handsetor press the SPEAKER button before you begin dialing.
