9ASSEMBLING YOUR KEYSET• Place the keyset face down on a flat surface.• Insert notched ends of the support bracket into the channels located in theupper section of the bottom panel. Push towards the top of the keyset to lockin.• Plug the handset cord into the jack marked with the symbol.• Route the handset cord out the RIGHT side of the keyset as you look at it facedown.• Plug an eight-conductor ethernet cable, from the wall, into the jack markedLAN on the back of the keyset. (Connect the ITP keyset to any port on the localnetwork).• If your ITP will share LAN connection with a PC, plug an eight-conductor eth-ernet cable, from the PC, into the jack marked PC on the back of the keyset.• Plug the power connector, from the power adapter provided, into the powerjack on the back of the keyset. The power adapter is not required if the ITP isconnected to a LAN connection that provides power over the ethernet. TheITP-5112L supports the power over ethernet feature when it is connected toa IEEE 802.3af compliant LAN switch or power injector port.IMPORTANT NOTES:• Be careful not to connect the Network LAN cable into the PC connector of thephone.• To prevent damaging the keyset, only use the Power Adapter that came withthe 5112LD keyset.• This manual assumes that the ITP keysets are connected to a functioning localIP network. The local IP network must be able to communicate with the mainprocessor and MGI channels in the OfficeServ 100, OfficeServ 500, or in theOfficeServ 7000 Series systems over IP. This is assumed regardless of whetherthe IP keyset is on a local or remote network.• Before using your ITP-5112L phone, press the MENU button, selectSound/Screen, then select option 8,“Screen Saver”. If you choose “User Define”,you can set the time period for the Power Save Mode to occur or you canselect the interval the Power Save Mode occurs. During Power Save Mode thescreen will turn off.8ITP-5112L KEYSETColor LCD PanelDisplays a large quantityof information so thatthe users can easilysearch.Select Buttons (6)To select a specific itemthe user can simplypress the Select buttonnext to the item.Volume ButtonUsed to adjustthe volume ofthe handset,speakerphone,ringer, back-ground musicand page.ScreenButtonSelect Button (6)Dial ButtonSpeaker ButtonFor handsfree operation and ringing.Hold ButtonUsed to save a callwithout hanging-up on the currentcall.Transfer ButtonConference ButtonUsed to make a calls ofup to 5 parties.Microphone ButtonNavigation ButtonScrollButtonStatus IndicatorUsed to provideyour keyset status.
