Samsung OfficeServ SMT-i5243 User Manual

Also see for OfficeServ SMT-I5220: User manual User guide Setup guide User manual User guide

Contents

Finish the first call and hang up; the waiting call will ring.• Lift the handset.NOTE: Intercom calls will not go on Automatic Hold.CONFERENCE CALLSYou may conference up to five parties (you and four others) in any combination ofoutside lines and internal stations in any order.• While engaged in a conversation, press the CONF button and receive confer-ence tone.• Make another call, either intercom or outside, press the CONF button andreceive conference tone.• Make another call or press the CONF button to join all parties.• Repeat the last step until all parties are added.NOTE: When attempting to add another party to the conference and you are notable to reach the desired person, hang up. Simply press the CONF button again toreturn to your previous conversation.To drop a party from your conference call:• Press CONF and dial the extension or line number that is to be dropped.• Press CONF again to reestablish the conference.NOTE: To leave the conference, hang up. Control is passed to the next internal sta-tion. If there are no internal stations and you wish to leave outside lines connect-ed together in a trunk to trunk conference, press the CONF button plus the CALLbutton that the call appears on or follow the instructions to drop a party and useyour extension number. When they hang up, the lines will release automatically.Press CONF to rejoin a trunk to trunk conference.CONFERENCE SPLITTINGIf you are the controlling party of a conference and your keyset has the Auto Holdfeature turned on (See Customizing Your Keyset) and all of the outside lines involvedin the conference appear as buttons on your keyset, you can split the conferenceinto separate calls as follows:• Press any one of the outside line buttons. That outside line will remain steadygreen to indicate you are still connected to it. All other outside lines in theconference will be placed on system hold at your keyset. All intercom callersin the conference will be disconnected. You may now speak with each callerprivately and transfer them as usual or reestablish another conference.23first station to hang up, simply press another DSS button. ORPress the CALL button or C.O. line button to return to the outside party andbegin the transfer process again.When you are transferring a call to a keyset set for Voice Announce or AutoAnswer, the transferred call will always ring.NOTES:1. After the inside party answers, you may alternate back and forth between theparties by pressing the TRANSFER button.2. If you receive No More Calls tone, that station has no button available to re-ceive another call. Press TRANSFER to return to the other party.3. You cannot transfer an Intercom call by pressing a DSS button.You must pressthe TRANSFER button and dial the destination extension number.TRANSFER WITH CAMP-ONWhen you are transferring a call to another station and you receive a busy signal,you may camp the call on to this station. Simply hang up when you hear the busysignal. The called party will be alerted that a call is waiting for them.NOTE: If you receive No More Calls tone, that station has no button available toreceive another call. Press TRANSFER to return to the outside caller.TRANSFER TO VOICEMAILThis feature is used to send a call directly to a voice mailbox.Your keyset must havea correctly programmed VT button to accomplish this. To transfer a call directly toa voice mailbox:• While on a call, press the VT button and dial the mailbox number.• Hang up when dialing is completed.CALL WAITINGIf an outside call has been camped-on to your phone or another station hascamped-on to you:• You will hear a tone in the earpiece and the call that is waiting for you(camped-on) will flash. In addition the bottom line of the display will indicatethe number of the station or trunk party camped-on.• Press the flashing button to answer; your other call will go on hold automati-cally if your station has the Automatic Hold feature set. If not, you must pressHOLD and then the flashing button OR22