74Configure the network settingsStep 1Click "Start" on the task bar, and then click "ControlPanel".→ The control panel will be displayed.Important:• Log in to the PC as an administrator.Step 2Click the "Network and Internet Connections" icon.→ The "Network and Internet Connections" windowwill be displayed.Step 3Click "Network Connections".→ The "Network Connections" window will be dis-played.From this page to the "Disk management" chapter (☞ page 121), the instructions of how to operate therecorder using a web browser are provided.When operating the recorder using a web browser, it is necessary in advance to configure the network settingsof the recorder and a PC.When the network settings of the PC are as follows, it is unnecessary to configure the settings. It is possible toconfigure the settings and operate the recorder using a web browser after completing the connection.IP address: 192.168.0.2 – 192.168.0.249, 192.168.0.251 – 192.168.0.254Subnet mask: 255.255.255.0Default gateway: 192.168.0.1When the settings are configured differently from the above, configure the network settings of the recorder or aPC.Configure the network settings of the recorderTo conform the settings of the recorder to the environment of PC’s, configure the settings using the buttons onthe front panel of the recorder.Refer to the chapter relating to the [Basic] tab of "Network" of the setup menu for how to operate (☞ InstallationGuide).Configure the network settings of the PCThe TCP/IP setting of the PC shall be changed to conform to the settings of the recorder.When using the recorder with the default (IP address: 192.168.0.250), set the IP address of the PC to"192.168.1.xxx (a number from 2 to 254 except 250 (this recorder))".In these operating instructions, the settings are performed on Windows XP as examples. Refer to the operatinginstructions of the respective OS for further information.
