114Operate the cameraIt is possible to operate the following camera operations when displaying live images from a combination cam-era.Panning/Tilting: Adjust the horizontal/vertical position of images from the camera.Zoom: Zoom in/out images from the cameraFocus: Adjust the focus of the camera.Iris: Adjust the lens iris of the cameraPreset position function: Register preset positions and move the camera direction to the registered presetposition.Auto function: Activate the auto function of the camera according to the settings of the cameraNote:• The camera operation can be performed only when displaying images on a 1-screen on monitor 1.• Depending on the model of the camera, some operations may not work.• When a user with a higher user priority is operating at the same time, it may be impossible to operate thecamera. Refer to the Installation Guide for further information about the priority.• Refer to page 118 for how to display the setup page of the camera and configure the settings of the camera.Panning/TiltingAdjust the horizontal/vertical position of images from the camera.Step 1Display the top page of the operation window.(☞ Page 77)Step 2Display live images from the camera on a 1-screen,and then click the [CAM] tab.→ The [CAM] tab will be displayed.Step 3Adjust the horizontal position and the vertical positionof the camera (direction) by any of the following.Control buttons: Click to move (pan/tilt) a camera inthe clicked direction.Control pad: Click to move (pan/tilt) a camera in theclicked direction. Panning/tilting speed willbecome faster if a clicked point gets farther fromthe center point of the control pad.Image display area: Click the desired point to belocated at the center of the angular field of view.The camera will move to locate the clicked pointas the center point in the image display area.
