62Operation and configuration when connectingthe recorders in cascading connectionWhen connecting the recorders (up to 5 recorders) in cascading connection, all images managed by the con-nected recorders can be monitored on a single monitor.The following are descriptions of how to operate when the recorders are connected in cascading connection. Tooperate the recorders connected in cascading connection, it is necessary to configure the settings in advance.Refer to the Installation Guide for further information.Important:• Audio cables can also be connected in cascading connection.• When trying to display the search window for another recorder, the search window may sometimes not bedisplayed. In this case, retry the operation to display the search window.ConfigurationConfigure the settings required for cascading connection. Operations and settings of the WJ-HD716K are thesame as that of the WJ-HD616K.For WJ-HD616KSelect "On" for "Cascade" on the "Cascade" tab under "Display" of the setup menu of the recorder to be con-nected in cascading connection. Set the unit addresses of recorders as follows.WJ-HD616K Unit address (system) Unit address (controller)First recorder 001 Select a number except 001 - 004 and not usedfor the other devices.Second recorder 002Third recorder 003Fourth recorder 004Fifth recorder 005Settings of a system controllerSet the unit addresses of system controllers as follows.System controller Unit address RemarksFirst system controller 001 It is possible to operate all monitor 1 and monitor2 connected to the first through fifth WJ-HD616K.Second system controller 002 Monitor 1 and monitor 2 connected to the firstthrough the fifth WJ-HD616K are available to oper-ate. However, camera selection on monitor 2 isunavailable when "Off" is selected for "Cascadesequence".Third system controller 003Fourth system controller 004
