57Event action Alarm mode Activity detection mode OffStart recording b b XDisplay event information on the screen b X XBlink the alarm indicator b X XSound the buzzer b X XSwitch to the camera channel in which an alarm occurred b X XMove the camera to the preset position b b XSend a mail that notifies of an event occurrence b X XSend a PS·Data command that notifies of an event occur-rence b X XOutput signals from the ALARM connector and the ALARM/CONTROL connector on the rear of the recorder b X XFile event logs b b bSend recorded images to an FTP server b X XProvide an alarm notification to a PC according to thePanasonic alarm protocol setting b X XCancel the alarm actionThe recorder will take an alarm action according to the settings configured in advance when an event occurs inthe alarm mode (ALM). To cancel the alarm action, press the [ALARM RESET] button on the front panel or clickthe alarm icon on the status bar displayed on monitor 2.When the "Alarm auto reset" setting on the "Common" tab under "Event" of the setup menu is set to "2s", "5s","10s", "20s", "30s", "1min", "3min" or "5min" (☞ Installation Guide), the following actions will automatically betaken without canceling the alarm action by pressing the [ALARM RESET] button.• The alarm indicator on the front panel will stop blinking and light steadily.• The event information displayed on the monitor will disappear.• The sounding buzzer and the alarm output will stop.• The camera where the alarm had occurred will return to the previous status.Step 1Press the [ALARM RESET] button on the front panelor click the [ALM] icon on the status bar displayed onmonitor 2.→ The alarm action will be canceled and the alarmindicator will go off.Note:• When the alarm action is canceled, the eventrecording will stop and return to the operationalstatus just before the event occurred.
