2.3.4 Quick SetupDescriptionIt is possible to set up the basic PBX parameters using a PC. When a PC accesses the PBX for the first timewith the Installer Level Programmer Code (® 2.3.1 PC Programming), Quick Setup display will appearautomatically. The following items can be programmed as desired:Item Parameter DescriptionDate & Time Year/Month/Date/Hour/MinuteThe date and time set on the PC will be used.System Password 4–10 characters Enter the system password for installer (®2.3.3 Password Security).Operator & Manager Extension Number Assign the PBX operator to all time modes (day/lunch/break/night) (® 2.2.5 Operator Features). The extensionassigned as the PBX operators is automatically allowedto perform manager operation (® 2.2.6 ManagerFeatures).Flexible NumberingFeature1. Type 1(with )2. Type 2(without )If "Type 1 (with )" is selected, " " must prefix all featurenumbers (except access numbers) when an extensionuser wants to use a feature.[Example] Call Pickup feature numberType 1 (with ): 41Type 2 (without ): 41For default of the flexible numbers, refer to the [FlexibleNumbering Table (available while a dial tone is heard)](® 2.3.6 Flexible Numbering/Fixed Numbering).Extension From 101/from 201 Determines the number from which default extensionnumbers begin.Operator 0/9 The feature number for Operator Call can be selected.CO Access 0/1/9 The feature number for Idle Line Access can be selected.CO Dialling Mode Pulse/DTMF Selects the type of signal used to dial out to the analoguetrunk through LCOT/CLCOT cards.Note that the programmable items may vary depending on the version of Maintenance Console being used.Feature Guide 3512.3.4 Quick Setup
