1.30.6.1 PS Roaming by Network ICD GroupDescriptionOne PS can be registered to up to 4 PBXs in a private network, and a Network ICD group created for the PSat each PBX, with virtual PSs set to forward to the other PBXs in the network. When a call to the PS is receivedat one of the PBXs, the call rings simultaneously at all PBXs in the network to which that PS is registered.PBX-1Private networkPBX-2Telephone CompanyVirtual PS3Virtual PS2Virtual PS1PBX-3PBX-4ICD GroupEach virtual PS is set to forward calls to the extension number of the actual PS as registered at one of theother PBXs.Then, an Incoming Call Distribution (ICD) Group is created containing the registered PS and the virtual PSs.When a call is received at one of the PBXs, it is forwarded to all of the other PBXs. One private network channelis used to forward an incoming call to one other PBX. Therefore, if a PS is registered at 3 other PBXs, 3 privatenetwork channels are needed to forward a single call to all of the PBXs.Each PBX can store the current communication status of each PS (In Range or Out of Range). If the status ofthe PS is set to Out of Range when a call is received, the call will be refused and the private network channelwill be released immediately. Since the PS can only be set to In Range at a single PBX at one time, any otherPBXs to which the call is transferred will refuse the call, releasing the private network channels.Conditions• Hardware Requirement:The KX-TDA0920 SD Memory Card for Software Upgrade to Enhanced Version• If no signal is received from a PS for the preprogrammed length of time when an incoming call is received,the communication status of the PS is set to Out of Range, if enabled through system programming.• When a PS comes within range of a certain PBX, Out of Range status is automatically released.However, in some negative wireless network conditions, Out of Range status may not be releasedautomatically. In this case, the PS user can manually release Out of Range status by pressing the TALKbutton and confirming that a dial tone can be heard from the PBX.320 Feature Guide1.30.6 Network ICD Group
