1.11.6 Flash/Recall/TerminateDescriptionThe FLASH/RECALL button (Flash/Recall mode or Terminate mode) or Terminate button (Terminate mode)is used when a PT user disconnects the current call and originates another call without hanging up first. Itperforms the same function as going on-hook and then going off-hook.[Explanation of Each Mode]Flash/Recall Mode: Disconnects the line. The extension user hears the dial tone from the line used last. Forexample, if a trunk call is disconnected, the extension user will hear a new dial tone from the telephonecompany.Terminate Mode: Disconnects the line. The extension user hears the dial tone determined by the LinePreference—Outgoing setting. (® 1.5.5.2 Line Preference—Outgoing)Conditions• FLASH/RECALL Button ModeOne of the following modes can be selected for each extension through system programming:– Flash/Recall mode– Terminate mode– External Feature Access (EFA) mode. (® 1.11.7 External Feature Access (EFA))• Terminate ButtonA flexible button can be customised as the Terminate button.• Disconnect Time (Only for Flash/Recall Mode)The amount of time between successive accesses to the same trunk is programmable for each trunk port.• This feature outputs an SMDR call record (® 1.26.1 Station Message Detail Recording (SMDR)), restartsthe call timer, inserts the automatic pause, and checks the TRS/Barring level (® 1.9.1 Toll Restriction(TRS)/Call Barring (Barring)) again.• The Terminate feature will be performed when pressing the FLASH/RECALL button regardless of the modethat the FLASH/RECALL button has been set to, in the following situations:– When a call is made using ARS. (® 1.10.1 Automatic Route Selection (ARS))– When a trunk call is made with the INTERCOM button.– When a trunk call is made with an ICD group button.PT Programming Manual References[418] LCOT Disconnect TimeFeature Guide References1.20.2 Flexible ButtonsFeature Guide 1371.11.6 Flash/Recall/Terminate
