Caller’s Name ReferenceA name can also be shown on the display or SMDR. The PBX searches for the name in the following order:1. Personal Speed Dialling data of the original called extension2. System Speed Dialling (Caller ID) Table3. Caller ID name received from the public line (Caller ID Name Reference)If the name is not found, it will not be displayed.Conditions[General]• Caller ID signalling type can be selected through system programming.• The Caller ID Name Reference is only available for calls from the public network.[Caller ID to SLT Port]• Hardware Requirement: An MCSLC16 card or MCSLC24 card• This feature complies with ETSI (European Telecommunications Standards Institute)-type FSK andBellcore-type FSK.• When the caller’s number is sent to an SLT, a Trunk Access number can be automatically added to thetelephone number through system programming for calling back.• When the caller’s number exceeds 16 digits, the SLT receives only the first 16 digits, not counting thepreceding Trunk Access number (if it is programmed to be added).• If a call is transferred to an SLT, the transferring extension’s information will be shown on the SLT. If thetransferring extension goes on-hook before the call is answered, the original caller’s information will beshown.• When the Caller ID has information, such as private, out of area, or long distance, the information will beshown instead of the caller’s number and name.• Even if the caller’s name is sent, the name may not be shown depending on the type of SLT.• Incoming Call Log information is not shown on the SLT.• Caller ID shows whether the call is an intercom or trunk call by default. This setting can be disabled throughsystem programming.• A caller ID name received from the network via a PRI23 card will not be displayed on an SLT. However, ifthe received caller ID matches a System Speed Dialling entry, and a name is registered for that entry, itwill be displayed.PT Programming Manual References[001] System Speed Dialling Number[002] System Speed Dialling Name[490] Caller ID Signal TypeFeature Guide References1.6.1.5 Speed Dialling—Personal/System1.26.1 Station Message Detail Recording (SMDR)190 Feature Guide1.18.1 Caller ID
