Notes on Using Your Server 1-7Installation, Relocation, Storage, and ConnectionWARNINGDisconnect the power cord(s) before installing or removing the server.Make sure to power off the server and disconnect the power cord(s) from apower outlet before installing/removing the server. All voltage is removed onlywhen the power cords are unplugged.CAUTIONNever attempt to lift the server only by yourself.The server weighs max. 21 kg (depending on its hardware configuration).Carrying the server only by yourself may strain your back. Hold the server firmlyby its bottom with another person to carry it. Do not hold the front door to lift theserver. The front door may be disengaged from the server, causing personalinjury.Do not install the server in any place other than specified.Do not install the server in the following places or any place other than specifiedin this User's Guide. Failure to follow this instruction may cause a fire. a dusty place a humid place such as near a boiler a place exposed to direct sunlight an unstable placeDo not install the server on a rack with leaving covers removed.Do not install the server on a rack with the cover being removed. Failure tofollow this instruction may reduce the cooling effect in the server to result insome malfunction and/or dusts to enter the server to result in a fire or electricshock.Do not pinch your finger with rails or other components.Note sufficiently that your fingers may not be caught between a rail and anothermechanical part or cut by a rail at installation or removal of the server from therack.Do not apply any load on the server pulled out from the rack.Do not apply any load on the server pulled out from the rack. Doing so bendsthe frame of the server. Consequently, the server cannot be pushed back intothe rack. Placing an object on the server may also cause personal injury if theserver drops.
